User manual FORD CROWN-VICTORIA-2004

[. . . ] Table of Contents Introduction Instrument Cluster Warning and control lights Gauges 4 10 10 15 Entertainment Systems AM/FM stereo cassette with CD AM/FM stereo with CD AM/FM stereo AM/FM stereo cassette CD changer 20 20 23 26 28 30 Climate Controls Manual heating and air conditioning Electronic automatic temperature control Rear window defroster 34 34 35 37 Lights Headlamps Turn signal control Bulb replacement 38 38 40 41 Driver Controls Windshield wiper/washer control Steering wheel adjustment Power windows Mirrors Speed control Message center 47 47 48 57 58 60 68 Locks and Security Keys Locks Anti-theft system 73 73 73 75 1 Table of Contents Seating and Safety Restraints Seating Safety restraints Air bags Child restraints 87 87 91 105 112 Driving Starting Brakes Traction control Air suspension Transmission operation Vehicle loading Trailer towing Recreational towing 124 124 128 131 133 134 139 141 144 Roadside Emergencies Getting roadside assistance Hazard flasher switch Fuel pump shut-off switch Fuses and relays Changing tires Jump starting Wrecker towing 145 145 146 146 147 155 161 167 Customer Assistance Reporting safety defects (U. S. only) 168 176 Cleaning 177 2 Table of Contents Maintenance and Specifications Engine compartment Engine oil Battery Fuel information Air filter(s) Tire Information Part numbers Refill capacities Lubricant specifications 183 185 186 190 198 212 214 226 227 228 Accessories Index 235 237 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Ford may change the contents without notice and without incurring obligation. [. . . ] Make sure the gearshift is in P (Park). 125 Driving 4. Make sure the parking brake is set. HOOD 5. Turn the key to 4 (ON) without turning the key to 5 (START). 4 3 5 2 1 126 Driving Make sure the corresponding lights illuminate or illuminate briefly. If a light fails to illuminate, have the vehicle serviced. · If the driver's safety belt is fastened, the Starting the engine 1. Turn the key to 4 (ON) without turning the key to 5 (START). Turn the key to 5 (START), then release the key as soon as the engine starts. Excessive cranking could damage the starter. light may not illuminate. 4 3 5 2 1 Note: If the engine does not start within five seconds on the first try, turn the key to 3 (OFF), wait 10 seconds and try again. If the engine still fails to start, press the accelerator to the floor and try again; this will allow the engine to crank with the fuel shut off in case the engine is flooded with fuel. Using the engine block heater (if equipped) Use of an engine block heater is strongly recommended if you live in a region where temperatures reach -10°F (-23°C) or below. For best results, plug the heater in at least three hours before starting the vehicle. The heater can be plugged in the night before starting the vehicle. 127 Driving To reduce the risk of electrical shock, do not use your heater with ungrounded electrical systems or two-pronged (cheater) adapters. Guarding against exhaust fumes Carbon monoxide is present in exhaust fumes. Take precautions to avoid its dangerous effects. If you smell exhaust fumes inside your vehicle, have your dealer inspect your vehicle immediately. Do not drive if you smell exhaust fumes. Important ventilating information If the engine is idling while the vehicle is stopped for a long period of time, open the windows at least one inch (2. 5 cm) or adjust the heating or air conditioning to bring in fresh air. BRAKES Your service brakes are self-adjusting. Refer to the scheduled maintenance guide for scheduled maintenance. Occasional brake noise is normal and often does not indicate a performance concern with the vehicle's brake system. [. . . ] VIN: XXXXXXXXXXXXXXXXXX XXXXX TYPE: XXXXXXXXXXXXXXX XXXXX EXT PNT: XXXXXX XXXXXX RC: XX DSO: XXXX BAR INT TR TP/PS R AXLE TR SPR X XX XXX X XX X XXXX UPC F85B-1520472-AB Vehicle identification number (VIN) The vehicle identification number is attached to a metal tag and is located on the driver side instrument panel. (Please note that in the graphic XXXX is representative of your vehicle identification number. ) XXXXXXXXXXXXXXXXX 1. Brake type and gross vehicle weight rating (GVWR) 3. Production sequence number 232 Maintenance and Specifications Engine number The engine number (the last eight numbers of the vehicle identification number) is stamped on the engine block, transmission, frame and transfer case (if equipped). [. . . ]