User manual FORD THUNDERBIRD-2004

[. . . ] Table of Contents Introduction Instrument Cluster Warning and control lights Gauges 4 10 10 14 Entertainment Systems AM/FM stereo with in-dash six CD 16 16 Climate Controls Electronic automatic temperature control Rear window defroster 22 22 25 Lights Headlamps Turn signal control Bulb replacement 27 27 30 30 Driver Controls Windshield wiper/washer control Steering wheel adjustment Power windows Mirrors Speed control 38 38 39 40 41 42 Locks and Security Keys Locks Anti-theft system 61 61 61 64 1 Table of Contents Seating and Safety Restraints Seating Safety restraints Air bags Child restraints 73 73 76 86 96 Driving Starting Brakes Traction control/AdvanceTrac Transmission operation Vehicle loading Trailer towing Recreational towing 108 108 111 113 114 121 124 124 Roadside Emergencies Getting roadside assistance Hazard flasher switch Fuel pump shut-off switch Fuses and relays Changing tires Jump starting Wrecker towing 125 125 126 126 127 136 142 148 Customer Assistance Reporting safety defects (U. S. only) 149 157 Cleaning 158 2 Table of Contents Maintenance and Specifications Engine compartment Engine oil Battery Fuel information Air filter(s) Tire Information Part numbers Refill capacities Lubricant specifications 164 166 167 170 177 189 192 204 205 207 Accessories Index 214 216 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Ford may change the contents without notice and without incurring obligation. [. . . ] If the engine still fails to start, press the accelerator to the floor and try again; this will allow the engine to crank with the fuel shut off in case the engine is flooded with fuel. Using the engine block heater (if equipped) An engine block heater warms the engine coolant which aids in starting and heater/defroster performance. Use of an engine block heater is 110 Driving strongly recommended if you live in a region where temperatures reach -23° C (-10° F) or below. For best results, plug the heater in at least three hours before starting the vehicle. The heater can be plugged in the night before starting the vehicle. To reduce the risk of electrical shock, do not use your heater with ungrounded electrical systems or two-pronged (cheater) adapters. Guarding against exhaust fumes Carbon monoxide is present in exhaust fumes. Take precautions to avoid its dangerous effects. If you smell exhaust fumes inside your vehicle, have your dealer inspect your vehicle immediately. Do not drive if you smell exhaust fumes. Important ventilating information If the engine is idling while the vehicle is stopped for a long period of time, open the windows at least 2. 5 cm (one inch) or adjust the heating or air conditioning to bring in fresh air. BRAKES Occasional brake noise is normal. If a metal-to-metal, continuous grinding or continuous squeal sound is present, the brake linings may be worn-out and should be inspected by a qualified service technician. If the vehicle has continuous vibration or shudder in the steering wheel while braking, the vehicle should be inspected by a qualified service technician. Refer to Brake system warning BRAKE light in the Instrument Cluster chapter for information on the brake !Four-wheel anti-lock brake system (ABS) Your vehicle is equipped with an Anti-lock Braking System (ABS). This system helps you maintain steering control during emergency stops by keeping the brakes from locking. Noise from the ABS pump motor and brake pedal pulsation may be observed during ABS braking; this is normal and should be no reason for concern. 111 Driving ABS warning lamp The ABS lamp in the instrument cluster momentarily illuminates ABS when the ignition is turned on. If the light does not illuminate during start up, remains on or flashes, the ABS may be disabled and may need to be serviced. Even when the ABS is disabled, BRAKE normal braking is still effective. P illuminates with the parking brake released, have your brake system serviced immediately. ) Using ABS When hard braking is required, apply continuous force on the brake pedal; do not pump the brake pedal since this will reduce the effectiveness of the ABS and will increase your vehicle's stopping distance. [. . . ] IN U. S. A. DATE: XXXXX GVWR:XXXXXXXXXXXX FRONT GAWR: XXXXXX/XXXXXXX REAR GAWR: XXXXXXX/XXXXXXX THIS VEHICLE CONFORMS TO ALL APPLICABLE FEDERAL MOTOR VEHICLE SAFETY, BUMPER, AND THEFT PREVENTION STANDARDS IN EFFECT ON THE DATE OF MANUFACTURE SHOWN ABOVE. VIN: XXXXXXXXXXXXXXXXXX XXXXX TYPE: XXXXXXXXXXXXXXX XXXXX EXT PNT: XXXXXX XXXXXX RC: XX DSO: XXXX BAR INT TR TP/PS R AXLE TR SPR X XX XXX X XX X XXXX UPC F85B-1520472-AB 210 Maintenance and Specifications Vehicle identification number (VIN) The vehicle identification number is attached to a metal tag and is located on the driver side instrument panel. (Please note that in the graphic XXXX is representative of your vehicle identification number. ) XXXXXXXXXXXXXXXXX 1. Brake type and gross vehicle weight rating (GVWR) 3. [. . . ]