User manual FOSSIL DIGITAL CALLER ID WATCH

[. . . ] If the battery level is low, the Bluetooth® function is automatically turned off. Turn the Bluetooth® function on again when the battery is fully charged. To charge the battery 1. Connect the battery charger plug to the charging clip with the symbols on the charger and clip facing in the same direction. Connect the charging clip to the watch by opening the clip and sliding it over the watch. [. . . ] This makes your phone visible to other Bluetooth® devices. Turn the Bluetooth® function on in your watch. Turn the pairing mode function on in your watch. Prepare your phone according to the phone's user guide on how to pair a Bluetooth® device. For some phones you may need to enter a passcode. After you have paired your watch with a phone, the watch will automatically connect to the phone as soon as the phone is on and within range. To turn a setting on or off 1. Press the bottom key repeatedly until the setting is highlighted. Press the top key to turn the setting on or off. Calls When the phone rings the watch vibrates and a previously saved name or number of the caller is displayed. * You can mute or reject the call by pressing the top key. *The information displayed will vary depending on your phone model. To mute an incoming call Press the top key. Battery status To check the watch battery status Press the top key. ° ° To reject an incoming call Press the top key twice. Date °° To check the phone date Press the top key once. The watch battery status is also shown. 2006/09/13 Time To check the phone time Press the top key twice. The phone time, watch battery status and Bluetooth® function status are also shown. Text messages When message notification is on, the watch vibrates and the appears when you receive a text message. If you have unread messages in your phone inbox, you will not get additional notifications when you receive new text messages. °° To turn message notification on 1. Press the bottom key repeatedly to select 2. appears. . To turn message notification off 1. Press the bottom key repeatedly to select 2. appears. . 10 14:20 11 Out of range The watch vibrates and the of range. icon appears when the phone is out Troubleshooting Battery capacity If the battery does not work properly it needs to be replaced by an authorized service center. The watch continues searching for the phone for 30 minutes. We recommend that your watch and phone are within a range of 2 meters. The connection may be improved if there are no solid objects between your watch and phone. Software version To check software version: 1. Press the bottom key repeatedly to select 2. [. . . ] Compliance Statement (Part 1. 1) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 1 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]