User manual FOSTEX 4050

[. . . ] You can control up to five songs on a single hard disk. Pasting data to any individual track, as well as pasting to multiple tracks simultaneously. The following functions have been changed and/or added in SETUP mode: Compatible with Fostex System exclusive Message to allow for editing from The maximum number of changing points in a Tempo Map is new 64 for a The maximum number to Tempo Map change points is new 64 for a time signature, and 64 for a tempo. Part of the key function has been changed in Version 2. [. . . ] When recording is complete, press the STOP button on both the DMT-8 and the digital device. After digital recording is complete, or during the time when you are not performing digital recording, set the digital input L/R channels to " -" (no assing). If the digital input channels remain assigned to the tracks and you set the tracks in recording mode (or in input monitoring mode), abnormal digital signals ("DIGITAL IN" is blinking) may cause the digital signals to from loops and oscillate internally, leading to possible damage to the external speakers. After completing digital recording, if you wish to continue a different digital recording session, make sure to supply correct digital signals to the DMT-8 unitl a series of digital recording sessions is finished. (Do not remove the optical cable or turn the power to the external device during the session. ) When you are performing a new digital recording session (or input monitoring), abnormal digital signals ("DIGITAL IN" is blinking) may cause the digital signals to from loops and oscillate internally, leading to possible damage to the external speakers. It is prohibited by law to record and use any piece of music for which copyright is possessed by a third party for commercial purpose - such as contents, broadcasting, and sales - any purpose other than for your personal pleasure. Using "dG out" of Setup menu, you can assign any of analog outputs 1-8 to digital output L or R. Select any one combination from "1-2", "3-4", "5-6", "7-8", and "s t" (DMT-8 stereo output L/R). This assignment will allow you to record digital data from the DMT-8's DATA OUT to an external digital device (such as CD, MD, etc. Tuning the power off will set this setting to default. The display will change to something similar to this, and the current value will appear. The letters "oFF" on the display will blink, and you can edit the value now. Turning the JOG dial counter-clockwise will select "oFF", and turning it clockwise will select "on". Press the STOP button or the EXIT/NO key to quit Setup mode. The DMT-8 requires an external digital as well as an external MTC for its slave operation. Therefore, connect the DATA OUT terminal off the master DMT-8 or DMT-8 Version 2. 0 (or D-80) to the DATA IN terminal of the slave unit using an optical cable. (You do not need to set any other settings on the master unit, since the master unit's DATA OUT connector always outputs digital signal. ) If you have not connected the units as described above (or in the slave unit does not receive digital signals correctly for some reason), the "DIGITAL IN" indicator of the slave unit will blink, indicating an error. If you connect one DMT-8 as a master with another DMT-8 as a slave, you can realize a 16-input/16-track multitracker system. Connect the DATA OUT connector of the master device with the DATA IN connector of the slave device using an optical cable. [. . . ] 0 will reply with "33 41 (<channel><channel>). " 23 42: digital out channel status request The inquiring the digital out channel setup status. When this command is received, D-80/DMT-8 ver2. When this command is received, D-80/DMT-8 ver2. [. . . ]