User manual FOSTEX 9046

[. . . ] * underlined: contracted distributors (as of August, 2000) <AUSTRIA> NAME: ATEC Audio-u. ADD: Im Winkel 5, A-2325 Velm, Austria TEL: (+43) 2234-74004, FAX: (+43) 2234-74074 <ITALY> NAME: General Music S. p. A. (RN), Italy TEL: (+39) 0541-959511, FAX: (+39) 0541-957404 <BELGIUM> NAME: EML Sound Industries NV ADD: Bijvennestraat 1A, B3500 Hasselt, Belgium TEL: (+32) 11-232355, FAX: (+32) 11-232172 <THE NETHERLANDS> NAME: IEMKE ROOS AUDIO B. [. . . ] By installing this DVD-RAM drive in the D2424, FMDS-3 Ver. 3. 0 or WAV file song data can be saved/loaded. For details on save/load, refer to the D2424 "Reference Manual. " Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. (For U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B Information Technology Equipment, pursuant to EN55022 (European Standard of Radio Frequency Emission for Information Technology Equipment). EN55022 is harmonized with CISPR22 (published by International Special Committee on Radio Interference). (For Europe) These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/TV technician for help. <CAUTION> · The optional DVD-RAM drive must be mounted by the Fostex authorized service facilities. For installation, please contact the Fostex distributor in your territory. · If a Model 9044 (BAY+CADDY) had already been installed in D2424, a Model 9046 DVD-RAM drive cannot be installed. In such a case, consult nearest Fostex Service facility. Caution: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. · Do not open the top cover of the DVD-RAM drive and never touch the internal parts in order to avoid EXPOSURE TO VISIBLE OR INVISIBLE LASER RADIATION. · When the power switch is On, do not place your eyes close to the front panel opening door and other openings to look into the inside of the DVD-RAM drive. D2424 front panel when installing the Model 9046 24TRACK DIGITAL RECORDER POWER DVD 24bit/96kHz Eject switch LASER Specification Class I LASER Product Wave Length: 655-666 nm, 775-815 nm Laser Power: No hazardous radiation is emitted with the safety protection. Headphone jack/sound control volume (Please refer to below. ) Hole for emergency eject Access LED Disk tray <Note> <DVD-RAM disks that can be used> There are some disks that can be used in the Model 9046 DVD-RAM drive. Please note that disks other than those listed below cannot be used. [. . . ] Please follow the suggestions below in handling and storing such disks. * Avoid locations of severe vibration. * Avoid conditions of extreme temperature and humidity. * Avoid wet locations or dampness. For Canada only · INDUSTRY CANADA (IC) STATEMENT OF CANADIAN INTERFERENCE-CAUSING EQUIPMENT REGULATION <Should tray of the DVD-RAM drive refuse to open> If the DVD-RAM drive tray does not come out switch off power to D2424 and carefully insert the ejecting tool included with Model 9046, into the hole at left side of the eject switch, slowly push it in until it stops, then push it further and the tray will come out a short distance. [. . . ]