User manual FOSTEX PH-50

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. "WARNING" "TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. " SAFETY INSTRUCTIONS 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. [. . . ] Do not use headphones for long hours at high sound levels. If the headphone is used under such condition, it could injure your hearing. Also, be careful not to rapidly raise the output control when using the headphone. Please use good sense to protect your hearing. 3. Retard the sound volume control when the headphone plug is connected or disconnected from the jack. Always turn down the sound volume control before the headphone is plugged or unplugged to the PHONES jack. If it is plugged or unplugged while the volume control is set too high, it could create noise and have hurt your ears. 2. Turn down all sound volume controls before switch on power. Be sure to fully turn off all sound volume controls when switching on/off power to the PH-50. 4. Switch off power when connecting external equipment to PH-50. Always switch off power to the PH-50 when connecting external equipment to it. Names and Functions of the Controls and Jacks Front Panel 5 5 5 5 5 2 5 3 PH-50 HEADPHONE AMP DISTRIBUTOR 1 0 10 0 10 0 10 0 10 0 10 0 10 PEAK 5 CAL POWER 1 2 3 4 5 AUX IN 4 ST MONO PHONES 0 10 INPUT 7 1. Headphone output level control knob [PHONES 1 ~ 5] For adjusting sound volume of the headphone plugged into PHONES jack 1 ~ 5. 6 5 5. Input master level control knob [INPUT] Adjusts the input signal level of equipment connected to the rear panel balanced input connectors (XLR or PHONE) or the unbalanced input jacks. Standard input level is obtained when the knob is set to CAL. 2. AUX input level control knob [AUX IN] This adjusts the input level of the external equipment connected to the rear panel AUX IN jacks. The signal, whose level is adjusted by this knob, is mixed with the signal whose level is adjusted by the INPUT knob and thus output from both the PHONES jack and CASCADE OUT jack. 6. Input image position selector switch [ST/MONO] Image position, of input signals from equipment connected to the rear panel balanced input connectors (XLR or PHONE) or the unbalanced input jacks (RCA), is selected by this switch. If switched to ST, the input signal will be output from the PHONES output jack or the CASCADE OUT jack, in stereo if switched to ST, or in monaural if switched to MONO. 3. Peak LED [PEAK] This will light when input is overloaded. Should this light frequently, turn down the INPUT knob. 7. Headphone jacks [PHONES 1 ~ 5] Headphones are plugged in here. Sound volume for each are adjusted by the headphone output level control knob located above each jack. 4. [. . . ] * The PH-50 can also be rack mounted by utilizing the separately sold rack mount adaptor. ADD: Kuiperbergweg 20, 1101 AG Amsterdam, The Netherlands TEL: (+31) 20-697-2121 FAX: (+31) 20-697-4201 <DENMARK> NAME: SC Sound ApS ADD: Malervej 2, DK-2630 Taastrup, Denmark TEL: (+45) 4399-8877, FAX: (+45) 4399-8077 <NORWAY> NAME: Siv. Box 145 Vinderen, 0319 Oslo 3, Norway TEL: (+47) 22-139900, FAX: (+47) 22-148259 <FINLAND> NAME: Noretron Audio ADD: Tonttumuorinkuja 4, FIN-02200 Espoo, Finland TEL: (+358) 0-5259330, FAX: (+358) 0-52593352 <PORTUGAL> NAME: Caius - Tecnologias Audio e Musica, Lda. [. . . ]