User manual FOX VANILLA RC

[. . . ] 2004 Rear Shock Owner's Manual FLOAT - FLOAT R - FLOAT L - FLOAT RL Vanilla - Vanilla R - Vanilla RC AVA - TALAS - SBC Enduro - SBC Brain - K2 Pull Shock FOX RACING SHOX 130 Hangar Way, Watsonville, CA 95076 831. 274. 6500 FAX 831. 768. 9312 E-Mail: service@foxracingshox. com Website: www. foxracingshox. com 1 Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General Information Contact Info . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Method of Shipping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Methods of Payment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Counter-clockwise rotation speeds the rebound. Move the dial one click at a time until desired rebound is achieved. Travel Adjustment Switch Rebound Adjuster Switch in Short -Travel Position Switch in Long-Travel Position 10 Air Volume Adjuster - AVA Some FLOAT shocks feature an Air Volume Adjuster or AVA. AVA technology affords a new level of fine tuning adjustment for mountain bike rear shocks. Turning the AVA ring increases or decreases the volume of the positive air spring chamber allowing the rider to alter the shape of the spring curve. The AVA system creates a shock that, in its smallest setting, is up to 30% more linear spring rate than a standard FLOAT shock. AVA allows as much as 200 lbs of adjustment in spring rate from fully closed to fully open when fully compressed. The AVA system is not intended to be used on the trail or on the fly. It is important to clean your shock, especially the threads of the AVA air sleeve prior to adjustment. In most cases, maximum air volume will be desired. Rotation of the AVA ring requires near complete deflation of the shock. Using a shock pump, let most or all of the air from the shock so that the AVA ring can be easily turned. Turn the ring until it just touches the wire ring which is snapped onto the air sleeve. Pressurize the shock and set sag as normal. If the shock seems to bottom out too easily or too often, deflate the shock, rotate the ring to the next setting on the air sleeve. Pressurize the shock, set sag and test again for full stroke performance. Repeat this process until the setting that best fits your riding style and terrain is determined. Air sleeve service can be performed as on other FLOAT shocks. Clean AVA seals after every other normal FLOAT seal service, especially if riding conditions are muddy or dusty. Carefully remove wire rings and air sleeves. Clean and inspect seals and parts for damage or wear. Refer to diagram for areas with critical sealing and lubrication needs. [. . . ] The red adjuster dial can be turned clockwise for slower rebound and counter-clockwise for faster rebound. There is a wide range of adjustment enabling the rider to tune the shock to any air pressure and riding condition. The proper rebound setting is a personal preference and varies depending on rider weight, riding style and riding conditions. As a general rule, rebound should be as fast as possible without kicking back and pushing the rider off the saddle when riding the bicycle in rough terrain. [. . . ]