User manual FOXCONN N570SM2AA

[. . . ] Statement: This manual is the intellectual property of Foxconn, Inc. Although the information in this manual may be changed or modified at any time, Foxconn does not obligate itself to inform the user of these changes. Trademark: All trademarks are the property of their respective owners. Version: User's Manual V1. 2 for N570SM2AA motherboard. P/N: 3A220BA00-000-G Symbol description: Note: refers to important information that can help you to use motherboard better. Attention: indicates that it may damage hardware or cause data loss, and tells you how to avoid such problems. [. . . ] vUSB Memory Type This option is used to set the USB Memory type. vUSB Keyboard Support This option is used to set whether the USB keyboard controller is enabled in a legacy operating system (such as DOS). The available setting values are: Dis abled and Enabled. vUSB Mouse Support This option is used to set whether the USB mouse controller is enabled in a legacy operating system (such as DOS). The available setting values are: Dis abled and Enabled. vHD Audio This option is used to set whether onboard AC97 Audio is enabled. The avail able setting values are: Disabled and Auto. vMAC / MAC1 LAN This option is used to set whether MAC LAN device is enalbed. vMAC / MAC1 Media Interface This option is used to set MAC Media Interface. vMAC LAN Boot ROM This option is used to decide whether to invoke the boot ROM of the MAC LAN chip. 35 Chapter 3 BIOS Description Onboard SuperIO Menu vOnboard FDC Controller This option is used to set whether the Onboard FDC Controller is enabled. The available setting values are: Disabled and Enabled. vOnboard Serial Port 1 This option is used to assign the I/O address and interrupt request (IRQ) for the onboard serial port 1. vIrDA IO/IRQ Select Use this option to select the IO/IRQ mode. The setting value is determined by the infrared module installed on the board. vIrDA Duplex Mode This item enables you to determine the infrared function of the onboard infrared chip. vOnboard Parallel Port This option allows you to determine onboard parallel port controller I/O address and interrupt request (IRQ). The setting values are: Disabled, 378/IRQ7, 278/IRQ5 and 3BC/IRQ7. vParallel Port Mode Select an address and corresponding interrupt for the onboard parallel port. The setting values are: SPP, EPP, ECP, ECP+EPP. vECP Mode Use DMA When the Parallel Port Mode is set to ECP or ECP+ EPP, this option is used to select the channel for the ECP mode. The setting values are: 1 and 3. 36 Chapter 3 Power Management Setup BIOS Description Power Management Setup Menu vACPI function ACPI stands for "Advanced Configuration and Power Interface". ACPI is a standard that defines power and configuration management interfaces between an operating system and the BIOS. [. . . ] The following Windows Setup screen appears listing both drivers: 74 Appendix 4. Press Enter to continue with operating system Installation. Be sure to copy the files from the floppy is complete, then take out the floppy. Follow the instructions on how to install operating system. [. . . ]