User manual FRIEDLAND D346

[. . . ] This product will not work with NiCd rechargeable batteries. q A small flathead screwdriver q A Philips crosshead screwdriver q Installation Please note: positioning the Bell Push or Door Chime on or near metal structures or reinforced PVCµ doors or door frames may reduce the transmission range. CR2032+ J CR 20 32 + Bell Push You can attach the Bell Push directly on to your door frame using the adhesive pad making sure the surface on which it is to be placed is clean and dry. Alternatively open the front cover using a flathead screwdriver (Diagram 1) and mount using the screws provided (See Diagram 2), ensuring that the rubber grommets (J in Diagram 2) remain in place. [. . . ] One of three alternative 2 note sequences which offer a choice of sound tone and are particularly suited to the hard of hearing. The Tune Selector in the Bell Push (D in Diagram 7) is factory set to position 1 making the Door Chime play the standard 2 note sequence. If you would prefer the 4 note sequence just move Tune Selector to position 2. If you require one of the alternative 2 note sequences to be played this can be easily done as follows: 1. Ensure that the Tune Select Control (D in Diagram 7) on the Bell Push is set to position 2. Set Control E in Diagram 8 on the Door Chime to position 1. Each time you press the Bell Push, the door chime will play the 4 note sequence and the three alternative 2 note sequences in rotation. Continue to press the Bell Push until you hear the note sequence you require. Set Control E in Diagram 8 to position 2 to lock the Door Chime into playing your chosen note sequence. In the case of battery failure, the alternative tone two note sequences will default to the 4 note setting. These can be reset using the procedure above. Your can change the note sequence at any time by using the procedure above. 5 G 2 1 0 Volume Control The Volume Control (F in Diagram 5) enables you to adjust the volume of your Door Chime at any time or turn it off completely so that only the light (G) flashes when the Bell Push is pressed. Mute sound with flashing light F System Codes - VITAL INFORMATION Your Libra Wirefree Bell Push and Door Chime use a coding system to ensure there is no interference to or from a neighbouring Friedland wirefree product. Your Bell Push and Door Chime need to have identical codes so that they can recognise each other. In the unlikely event that your Door Chime rings without your Bell Push being used, it means another Friedland wirefree product, either your own or a neighbour's, is using the same code as your own. You can then change your code by following this procedure:1. [. . . ] If Confidence Light (A) does not illuminate, replace the Bell Push battery. Check the system codes in both your Chime and Bell Push Set volume control to position 1 or 2 Change the system codes in both your Bell Push and Chime 8 ON 1 2 12345678 Caradon Friedland guarantees this product for 3 years from date of purchase. This does not effect your statutory rights. [. . . ]