User manual FRIEDLAND WIREFREE REMOTE KEYPAD

[. . . ] The Keypad is used to control the system by using a four digit User Access Code. The Keypad incorporates a Personal Attack (PA) and anti tamper protection features that will immediately initiate a Full Alarm condition when activated. [. . . ] Replace the rear cover and refit fixing screws. Refit and secure the Keypad onto the wall mounting plate. Note: The Keypad is supplied with a default User Access Code of: 1 2 3 4. For security reasons, it is recommended that this code is changed to another four digit number which only you and other users of the system know. Installing and Configuring the Remote Keypad Ensure that the Control Panel is in Test or Programming Mode, (or that the Siren is in Service Mode for single zone systems without a Control Panel), (refer to "System Installation and Operating Manual"). Testing the Remote Keypad Ensure that the Solar Siren is in Operating Mode and for Control Panel based systems the Control Panel is in Standby Mode, (refer to "System Installation and Operating Manual"). Press ? ? ? ? , to Arm the system. User Access code 1 4 7 0 2 5 8 ON 3 6 9 AIR 1 2. Press and hold and buttons together, after 2 1 approximately 2 seconds an alarm will be initiated. 2 LO W BA TT. 3. Press Fixing Screw Wall Fixing Plate ? ? ? ? , to Disarm the system User Access code and stop the siren. Operating the Remote Keypad Arm: Press Changing the User Access Code: Default Code: 1 2 3 4 ? ? ? ? , User Access code When using the Keypad the keys must be pressed firmly and within five seconds of each other. If you make a mistake, wait five seconds and recommence programming from the beginning of the sequence. To change the User Access Code, press the following keys in sequence: 1. Press 1 Part-Arm, (if applicable to system): Press Press ?? , , 1 for Part-Arm 1 for Part-Arm 2 User Access code 2 User Access code 2. Press 2 ? 1 ? ? ? current User Access code Delay Arm (single zone systems only): Press ? ? ? ? , 1 or , the 'on-air' LED will flash twice User Access code 4. Enter ? ? ? ? Disarm: Press new User Access code ? ? ? ? , User Access code 1 , the `on-air' LED will flash three times to confirm the 5. If the light does not flash, wait five seconds and re-enter the programming sequence from the beginning. Personal Attack/(PA) : Press and hold 1 and 2 together for more than 2 seconds. Battery The "LOW BATT" indicator on the front of the Keypad will start flashing when the Keypad battery level drops too low. [. . . ] ?, Press (hold) for approx 10s until the siren emits a single long beep (and LEDS flash three times). The Disarm key should be released during the long beep. Guarantee Novar ED&S undertakes to replace or repair at its discretion goods (excluding non rechargeable batteries) should they become defective within 1 year solely as a result of faulty materials and workmanship. Understandably if the product has not been installed, operated or maintained in accordance with the instructions, has not been used appropriately or if any attempt has been made to rectify, dismantle or alter the product in any way the guarantee will be invalidated. [. . . ]