User manual FRIGIDAIRE CGIH3047VF

[. . . ] Verify the anti-tip device has been installed to floor or wall. Ensure the anti-tip device is re-engaged to floor or wall when the range is moved. Do not operate the range without the anti-tip device in place and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. [. . . ] Use the information below to locate the bracket if template is not available). Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1-1/4" (32 mm) from wall when installed, you may use the wall or floor mount method. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1-1/4" (32 mm) from the wall when Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" (3 mm) is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage drawer. For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range and carefully attempt to tilt it forward. Power supply cord with 4-prong grounding plug It is the personal responsibilty of the consumer to have the appropiate outlet with the correct, properly grounded wall receptacle installed by a qualified electrician. Failure to follow this warning may cause serious injury, fire, or death. Plug the range power cable (4 conductors) into a 4 conductor range outlet. Outlet must be properly grounded and in accordance with the Canadian Electrical Code (CSA Standard (C22. 1 Part 1 -- latest edition) -- and any local electrical code requirements. Locate outlet 6" (152 mm) above the floor in the wall behind the range. grounding Instructions For personal safety, this appliance must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correct voltage, is correctly polarized and properly grounded in accordance with local codes. The serial plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the Kilowatt rating (power requirements) and Voltage ratings. [. . . ] Reinstall in reverse order making sure to level the range and check electrical connections. See pages 2 and 3 for proper anchoring instructions. Some models have a cool-air intake vent on the rear of the appliance. Before You Call for Service Read the "Before You Call" and operating instruction sections in your Use & Care Manual. [. . . ]