User manual FRIGIDAIRE FAQG7077KN INSTALLATION

[. . . ] For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read all of the following instructions before installing and using this appliance: Destroy the carton and plastic bags after the dryer is unpacked. Cartons covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. [. . . ] 6 Installer MUST anchor this (1) dryer or (2) dryer mounted on pedestal to the floor with approved Mobile Home Installation Kit - P/N 137067200. EXPLOSION HAZARD Do not install the dryer where gasoline or other flammables are kept or stored. Failure to do so can result in death, explosion, fire or burns. DO NOT INSTALL YOUR DRYER: 1 In an area exposed to dripping water or outside weather conditions. 2 In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. Floor MUST be solid with a maximum slope of 1 inch (2. 1 A dryer installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors. 2 No other fuel burning appliance shall be installed in the same closet as the gas dryer. 3 Your dryer needs the space around it for proper ventilation. DO NOT install your dryer in a closet with a solid door. 4 Closet door ventilation required: A minimum of 120 square inches (774. 2 cm²) of opening, equally divided at the top and bottom of the door, is required. Openings are required to be unobstructed when a door is installed. * Dryer must be vented straight back to achieve 0" (0 cm) rear installation. Freestand dryer on floor floor line Floor line * To obtain these minimal depth dimensions, dryer must be vented straight back. Using a quick-turn 90° elbow (right or down on freestanding dryer) adds approximately 0. 5cm)* to front of closed door * To obtain these minimal depth dimensions, dryer must be vented straight back. The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or a fire hazard. -approved strain relief must be installed onto power cord. If the strain relief is not attached, the cord can be pulled out of the dryer and can be cut by any movement of the cord, resulting in electrical shock. Do not use an aluminum wired receptacle with a copper wired power cord and plug (or vice versa). [. . . ] Remove and save the 2 screws and separate the hinge from inner door assembly. Attach it with the 2 pan head screws removed previously. Reinstall plastic plug in the square hole next to the hinge. Take care not to strip out the plastic holes. [. . . ]