User manual FRIGIDAIRE FFID2426TS

[. . . ] It contains important safety information for operating this appliance. It also has many suggestions for getting the best results from your dishwasher. Read all instructions before installing dishwasher. For your safety, please read and observe all safety instructions. [. . . ] The knock out plug must be removed from inside disposer inlet before making the final fit to drain hose. Before cutting drain hose access, check both sides of selected area to avoid interference. Cut a 2" diameter hole in shaded area shown in Figure 2. If the cabinet wall is wood, sand edges of hole until smooth and rounded. If cabinet wall is metal, cover all sharp edges with electrical or duct tape to avoid cutting drain hose. drying Vent Hose (if equipped) Care must be given during installation and removal of the dishwasher to avoid disconnection of the vent hose that is attached to the top of the dishwasher. Check chart for height opening and suggested adjustment. Move dishwasher to front of installation area. Loosen the front and rear leveling legs by turning counterclockwise. Front levelers should allow 1/4" below underside of countertop. If levelers have to be removed, make sure floor is free of obstructions. Place dishwasher inside cabinet area so that it is centered in opening. Use caution when moving dishwasher to prevent damage to dishwasher, floor, and cabinets. Remove lower rack to check that dishwasher is level from side to side by placing a level on the bottom of the inner door. Remove lower rack to check that dishwasher is level from front To back by placing the level at the bottom of the tub at the lower Plumbing material and drain hose must not come in contact with wiring or electrical components. Failure to follow this warning could result in personal injury from exposed wiring. Pull out unit and check to see if drain hose is correctly attached to the drain pump assembly. If drain hose is not attached to drain pump, follow the instruction sheet (included with drain hose) on how to correctly install the drain hose to the drain pump assembly. Move unit back in place while routing drain hose through access hole. Use caution to prevent damage to the dishwasher, floor and cabinets. IMPORTANT: Make sure there are no sharp bends or kinks that might restrict drain flow. IMPORTANT: Be careful not to overtighten clamp or you may damage end of hose. [. . . ] The kit utilizes the front frame of the dishwasher to secure the unit to the cabinet or partitions. Disconnect electrical power at the fuse box or circuit breaker box before beginning installation. Failure to follow this warning could result in death or serious injury. Cut Hazard Metal color panels are sharp and should be handled with care. [. . . ]