User manual FRIGIDAIRE FGB24T3ECA INSTALLATION

[. . . ] If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. FOR YOUR SAFETY: -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT TO DO IF YOU SMELL GAS: · Do not try to light any appliance. ⷠDo not touch any electrical switch; do not use any phone in your building. [. . . ] If an external electrical source is used, the appliance, when installed, must be electrically grounded in accordance with local codes or in their absence of local codes with the National Electric Code ANSI/NFPA No. Check all code rules and regulations for connecting the wall oven to be certain the installation conforms with all local, municipal and state codes as well as local utility regulations. Failure to comply with the above could result in a serious shock hazard. note: All hookups and adjustments shall be performed by qualified technicians. Disconnect electrical supply cord from wall receptacle before servicing wall oven. (Model with 1 ½ oven cavity only) Remove and lay aside the lower vent decorative trim that is taped to the side or to the top of the oven. The decorative trim will be fastened to the lower front of the oven after it has been installed in the cabinet. There is a 1 ½" height adjustment on models with extension panel (see figure 4). With this adjustment and a ½" trim overhang, a unit can be installed in existing openings 37 ½" to 39" high. Use the 4 mounting screws provided to fasten the front frame of the appliance to the cabinet (steps 1 below). Keep the 2 decorative screws to fix the decorative trim to the cabinet (step 2 below). The mounting holes in the front frame of appliance may be used as a template to locate the appliance mounting screw holes on the cabinet. 2 holes are located under the center vent trim on each side, the 2 other holes are visible when the drawer is opened. Optional: Install the decorative trim under the appliance (as shown on figure 6) using the 2 decorative screws supplied with the appliance. Move each panel down to the position that increases the oven height to fit your opening. Each position changes oven height approximately ½". Use the 2 screws provided in the miscellaneous parts bag, for mounting the appliance in the mounting holes on each side trim aside the central vent trim (figure 7). Important: Read these instructions carefully before connecting this unit to a gas supply. Figure 7 The units covered in these instructions are designed to operate on natural gas at 4" of manifold pressure or on LP gas at 10" of manifold pressure. A convertible pressure regulator is connected in series with the manifold of the wall oven unit and must remain in series with the supply line, regardless of which type of gas is being used. For proper operation, the maximum inlet pressure to the regulator must not exceed 14" of water column (W. To check the regulator, the inlet pressure must be at least 1" (or 3. [. . . ] Remove the cap from the pressure regulator. Turn the plunger upside down with the enlarge end TOWARDS regulator. External Shut Off Valve * Figure 10 IMPORTANT: Prior to attaching gas piping to the oven, move the shut-off valve support bracket to the left as far as possible and tighten its mounting screw from underneath the oven. This keeps the safety valve/ pressure regulator assembly from moving. [. . . ]