User manual FRIGIDAIRE FGHB2869LP INSTALLATION

[. . . ] 3 Remove the plastic cap from the water valve inlet at the rear of your refrigerator. 4 Slide the brass compression nut, then the ferrule (sleeve) onto copper tube. 5 Push the copper tube into water valve inlet as far as it will go (1/4 inch). 6 Slide the ferrule (sleeve) into valve and finger-tighten the compression nut onto valve. [. . . ] Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections: Sides & Top: 3/8 inch Rear: 1 inch Information about cabinetry construction for your new appliance is available for contractors. The ice maker's fill valve may operate noisily if the household water supply is shut off. ⷠAfter ensuring no water leaks exist at any connection, be sure to check for leaks again in 24 hours. If possible, use a hand truck to position the refrigerator directly in front of its cabinet enclosure. Be careful not to move the refrigerator beyond its water supply (copper tubing) connections. Plug in the power cord, and push the refrigerator straight back into place. Location of these materials may vary depending on your model. When changing controls, wait 24 hours before making additional adjustments. Room temperatures below 55°F (13°C) or above 110°F (43°C) will impair cooling ability of your refrigerator's compressor. By now, you have already removed your refrigerator's shipping carton. You may still need to use a hand truck to move it through close spaces or entrances. If the refrigerator is larger than an entrance, consider two options: · Remove the refrigerator doors (see how in your Use & Care Guide). Load refrigerator from side of cabinet only. Never use refrigerator handles to move the refrigerator. ⷠRemove tape from doors only after unit is in place. If you are installing your refrigerator without connecting it to a water supply, make sure the ice maker's power switch is turned Off (see the Use & Care Guide for more details). Shifting the refrigerator from side to side may damage flooring. ⷠDo not block the toe grille on the lower front of your refrigerator. [. . . ] Ice Maker House water supply connected to refrigerator No water leaks present at all connections - recheck in 24 hours Ice Maker is turned ON. Doors Handles are secure and tight Door seals completely to cabinet on all sides Freezer door is level across the top Leveling Refrigerator is level, side to side and tilted 1/4" (6mm) front to back Toe grille is properly attached to refrigerator Cabinet is setting solid on all corners Kit #53039117950, available from your dealer, provides all materials for a water supply installation, including 25 feet of copper tubing and full instructions. Raise the front of the refrigerator enough so the doors close freely when opened halfway. The refrigerator should slope 1/4 inch to 1/2 inch from front-to-back. [. . . ]