User manual FRIGIDAIRE FNDP15W INSTALLATION

[. . . ] If appliance has metal feet, unscrew them, remove the locking nut and reinstall the feet flush to the base. If locking nuts are not removed on units with metal feet, mounting holes in appliance will not align to mounting holes in brackets. Repeat leveling and rocking until all four (4) feet are sturdy on the floor and pedestal is level. Locate pedestal to within a few inches of its final location. [. . . ] Install 2 screws through each rear bracket into the base of the dryer. Attach each front clip to outer-most set of holes with 2 screws. Install a screw through each front bracket into the base of the dryer. Insert "A" tab of each rear bracket into the rear slots on rear of pedestal using rear bracket spacers. Install 2 screws through each rear bracket into aligning pedestal holes. Use the following instructions for mounting any of these types of dryers to the pedestal: - EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the dryer. Using two or more persons, slightly tip the dryer back and lift it onto the pedestal. Still tipped, slide the dryer back against the rear brackets so tabs on rear brackets engage the slots on the back of the dryer. Gently set down the front so the appliance is between the front and rear brackets. Attach each front clip to outer-most set of holes with 2 screws. Adjust the appliance side-to-side to align its mounting holes with the pedestal's bracket holes. Install a screw through each front bracket into the base of the dryer. Insert "B" tab of each rear bracket into the front slots on rear of pedestal. Install 2 screws through each rear bracket into aligning pedestal holes. Use the following instructions for mounting this type of washer to the pedestal: - EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the washer. Using two or more persons, slightly tip the washer back and lift it onto the pedestal. Still tipped, slide the washer back against the rear brackets and gently set down the front so the appliance is between the front and rear brackets. Remove 2 screws from service access below front panel. Remove 2 lower screws from backsheet of washer. Adjust the appliance side-to-side to align its mounting holes with the pedestal's bracket holes. Reinstall backsheet screws removed earlier through each rear bracket into the base of the washer. Attach each front clip to outer-most set of holes with 2 screws. [. . . ] Insert "B" tab of each rear bracket into the front slots on rear of pedestal. Install 2 screws through each rear bracket into aligning pedestal holes. For one year from date of purchase, when this pedestal is installed with the listed washer or dryer (see owners manual for specific model) and operated according to the information in the Use and Care Guide, Operating Instructions and Installation Instructions, the supplier will repair or replace any of its mechanical parts if they are defective in workmanship or material. This written warranty gives you specific rights. [. . . ]