User manual FRIGIDAIRE FPBM189KF INSTALLATION

[. . . ] This Over the Range Microwave Oven should be mounted against and supported by a flat vertical wall. The wall must be flat for proper installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2" x 4" wood studding and 3/8" or more thick dry wall or plaster/lath. [. . . ] REAR EXHAUST: If a rear or horizontal exhaust is to be used, care should be taken to align the exhaust with the space between the studs, or wall should be prepared at the time it is constructed by leaving enough space between wall studs to accommodate exhaust. MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3 1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 feet. Elbows, adapters, wall caps, roof caps, etc. Present additional resistance to air flow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total length, add the equivalent lengths of all transitions and adapters plus the length of all straight duct sections. Figure 3 shows the approximate feet of equivalent length of some typical ductwork parts. Use the values in parentheses for calculating air flow resistance equivalent, which should total less than 140 feet. Open the bottom of the carton, bend the carton flaps back and tilt the oven over to rest on plastic foam pad. Lift carton off oven and remove all packing materials, Installation Instructions, Wall Template, Top Template, Turntable and Turntable Support; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the ceiling in the oven cavity. Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact your dealer or Electrolux AUTHORIZED SERVICER. 1 1/2" Wood Bit or Metal Hole Cutter (if metal cabinet is used) Saw to cut exhaust opening (if needed) Protective Drop Cloth for product and range you may also use carton for protection Scissors Pencil Measure Tape The INSTALLATION HARDWARE items - are in a small bag. All items are in a bag packed below the oven. This Over the Range Microwave Oven is designed for adaptation to three types of hood ventilation systems. Recirculating requires the use of the Charcoal Filters, which have already been installed in the oven. Remove 3 screws from back edge and 5 screws from the top of Fan Cover Bracket. Save 3 screws to use them to attach Exhaust Damper Assembly to the wall later and discard remaining 5. Lift Hood Fan Unit carefully and slip wires out of cavity. Rotate the Hood Fan Unit 180° so that the Fan Blade Openings are facing the back of the oven. Use 1 Tapping Screw 4 x 8 mm from the INSTALLATION HARDWARE and tighten into place. This assembly will be mounted to the Outside Rear Exhaust cutout in future instructions. The Charcoal Filters should be replaced every 6 to 12 months, depending on use. [. . . ] Install the oven by tilting it forward and sliding it onto two tabs of the Mounting Plate. Use the two Top Cabinet Screws and two Flat Washers, supplied in the INSTALLATION HARDWARE, to attach the unit to the top cabinet. Secure the bottom of the oven to the Mounting Plate by using two Tapping Screws 4 x 8 mm from the INSTALLATION HARDWARE. (For Vertical Exhaust Only) Attach the Exhaust Damper Assembly to the fan Cover Bracket on the top of the outercase cabinet by sliding it into the slits in the same direction as the allow using screw (A) which removed at (C) VERTICAL EXHAUST STEP 1 on page 5. [. . . ]