User manual FRIGIDAIRE FPUH19D7LF

[. . . ] Use & Care of your All about the Freezer TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Electrical Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Copper Water Line Connection If you use stainless steel tubing - The nut and ferrule are already assembled on the tubing. Slide compression nut onto valve inlet and finger tighten compression nut onto valve. Tighten another half turn with a wrench; DO NOT over tighten. See Figure B. 12 ICE SERVICE ICE SERVICE Plastic Water Tubing to Ice Maker Fill Tube Steel Clamp If your freezer has an automatic icemaker, it will provide a sufficient supply of ice for normal use. During the initial startup of your freezer, however, no ice will be produced during the first 24 hours of operation. Automatic ice makers are also optional accessories that may be installed in some models at any time. Call your local dealer for information. Stainless Steel Waterline Water Valve Bracket Valve Inlet Water Valve Turning Your Ice Maker On After the plumbing connections have been completed, the water supply valve must be opened. Place the ice container under the ice maker, pushing it as far back as possible. Lower the wire signal arm to its "down" or ON position. New plumbing connections may cause the first production of ice cubes to be discolored or have an odd flavor. These first cubes should be discarded until the cubes produced are free of discoloration and taste. 6 ft. Stainless Steel Water Line From Household Water Supply Figure B. Stainless Steel Water Line Connection 5. With steel clamp and screw, secure water supply line (copper tubing only) to rear panel of freezer as shown. Coil excess water supply line (copper tubing only), about 2½ turns, behind freezer as shown and arrange coils so they do not vibrate or wear against any other surface. Turn ON water supply at shutoff valve and tighten any connections that leak. Reconnect freezer to electrical power source. To turn ice maker on, lower wire signal arm (side mounted) or set the ice maker's On/Off power switch to the "I" position (rear mounted). Turning Your Ice Maker Off To stop the ice maker, lift the wire signal arm until it clicks and locks in the "up" or OFF position. The ice maker also turns off automatically when the ice container is full. If your model has an adjustable freezer shelf, place the shelf in the lower position, so that the wire signal arm will hit the ice when the container is full. Ice Maker Tips · If the ice maker will be turned off for a long period of time, turn the water supply valve to the closed position. Ice cubes stored too long may develop an odd flavor. Empty the ice container and ensure that the wire signal arm is in its "down" or ON position. [. . . ] Louder sound levels when compressor comes on. * Modern freezers have increased storage capacity and more stable temperatures. * Freezer operates at higher pressures during the start of the ON cycle. When the surrounding noise level is low, you might hear the compressor running while it cools the interior. * This is normal. [. . . ]