User manual FRIGIDAIRE FRA053XT7

[. . . ] All about the Use &Care of your Room Air Conditioner TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Product Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Normal Sounds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. TO USE THE ENERGY SAVER FEATURE: YOU WILL SEE: DO THIS: PRESS MODE BUTTON CHOOSE Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling starts. ENERGY SAVER TlMER: DELAY STOP / START FEATURE FIRST DO THIS: PRESS TIMER BUTTON YOU WILL SEE HOW MUCH TIME IS CHOSEN: Note: For Delay Stop, the unit must be in the On position Note: For Delay Start, the unit must be in the Off position. To adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at 0. 5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7. 5, 7, etc. ). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Turning the unit "ON" or "OFF" at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens, the above steps have to be repeated again. All rights reserved. THEN DO THIS: PRESS UP/DOWN SET BUTTONS 6 2009 Electrolux Home Products, Inc. Operating Instructions Operating Instructions (continued) TO CHANGE TEMPERATURE DISPLAY: YOU WILL SEE: DO THIS: PRESS AND HOLD THE UP/DOWN BUTTONS TOGETHER FOR 3 SECONDS Note: The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. FAULT CODES TO TURN UNlT OFF: DO THIS: If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center. PRESS ON/ OFF BUTTON ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with. The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having to roll through to select another mode. The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees. After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored. Air Directional Louvers Air directional louvers control air flow direction. Your air conditioner has the louver type described below. (2-WAY) AUGER WHEEL Auger Type Rotate the Auger Wheel until the desired Left/Right direction is obtained. 2009 Electrolux Home Products, Inc. All rights reserved. 7 Care and Cleaning & Energy Saving Ideas Care and Cleaning Clean your air conditioner occasionally to keep it looking new. [. . . ] Service calls to correct the installation of your appliance or to instruct you how to use your appliance. Expenses for making the appliance accessible for servicing, such as removal of trim, cupboards, shelves, etc. , which are not a part of the appliance when it is shipped from the factory. Service calls to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other cosmetic parts. Surcharges including, but not limited to, any after hour, weekend, or holiday service calls, tolls, ferry trip charges, or mileage expense for service calls to remote areas, including the state of Alaska. [. . . ]