User manual FRIGIDAIRE FRA055XT70 INSTALLATION

[. . . ] Installation Instructions READ BEFORE INSTALLING UNIT OPP Window Mounting (5K~6. 5K BTU) edges that may be exposed: talled. Be sure it will support the weight of the unit over an extended period of time. NOTE: Mounting Hardware Qty. 7 the best way to store unit during winter, or when not in use. (For Wooden windows) 2 2 s) 1 weather seals window sash seal foam Top Rail Hardware Qty. [. . . ] Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. Slide the panel all the way in and repeat on the other side. FIG. 3 Top Rail Bottom Rail Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 4B) Lower sash must open sufficiently to allow a clear vertical opening of 13 inches (330 mm ). Side louvers and the rear of the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or garage. Fig. 4B INNER WINDOW SILL 330 mm INNER WINDOW SILL 330 mm INTERIOR WALL Wooden Windows Vinyl-Clad Windows Storm Window: SASH If the air conditoner is blocked by Storm Window, add wood as shown in FIG. 5, or remove storm window before air conditioner is installed. If Storm Window Frame must remain, be sure the drain holes or slots are not caulked or painted shut. Accumulated Rain Water or Condensation must be allowed to drain out. Storm window frame or other obstruction. 5 Board thickness as required, for proper pitch to rear, along entire sill. [. . . ] Keeping a firm grip on air conditioner, raise sash and carefully remove. Be careful not to spill any condensate water while lifting unit from window. [. . . ]