User manual FRIGIDAIRE FRA126CT10 INSTALLATION

[. . . ] Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended period of time. Wear protective gloves whenever lifting or carrying the unit. [. . . ] When installed, the flange for securing the panel in place to the window sill will be facing into the room. Hold the side Panel in one hand and gently pull back the center to free the open end. Slide the free end "I" section of the panel directly into the cabinet as shown in FIG. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. Slide the panel all the way in and repeat on the other side. FIG. 3 Top Rail Bottom Rail Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 4B) Lower sash must open sufficiently to allow a clear vertical opening of 15-1/2 inches (394 mm ). Side louvers and the rear of the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or garage. Fig. 4B INNER WINDOW SILL 394 mm INNER WINDOW SILL 394 mm INTERIOR WALL Wooden Windows Vinyl-Clad Windows Storm Window: SASH If the air conditoner is blocked by Storm Window, add wood as shown in FIG. 5, or remove storm window before air conditioner is installed. If Storm Window Frame must remain, be sure the drain holes or slots are not caulked or painted shut. Accumulated Rain Water or Condensation must be allowed to drain out. Storm window frame or other obstruction. [. . . ] 12B H INSIDE OUTSIDE INSIDE H OUTSIDE H=H1-H2 H about Wooden Window Bottom Rail H1 H2 Bottom Rail Vinyl-Clad Window Trim the weather seal with a proper length, peel off the protective backing and plug any gaps if needed Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. Remove sash seal from between windows, and unscrew sash lock. Remove screws installed through frame and framelock. [. . . ]