User manual FRIGIDAIRE PLHV36W7KC

[. . . ] OWNER'S GUIDE PLHV36W7KC READ AND SAVE THESE INSTRUCTIONS Contents Product Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7 Use and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Hood Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Hood installation height above cooktop is the users preference. The lower the hood above the cooktop, the more efficient the capturing of cooking odors, grease and smoke. We recommends the hood be installed 30-36" above the countertop. The lower height may be inconvenient for tall people and large cooking vessels. Check your ceiling height and the hood height maximum before you select your hood. 4 Installation Tools required for installation Screw driver (flat head, pozidrive n°2 and torx 10) Allen spanner 4mm Electric drill with twist bit Ø 10 mm Preparation of mounting surface (Drywall) 1. Select a mounting height comfortable for the user and mark on wall behind cooktop. Mark center line of cooktop and draw vertical line from bottom of hood to the ceiling. Tape template, matching center-line and hood bottom as shown in Figure 2. Mark centers of the 6 fastener locations through template on wall then remove template. Mark wall with horizontal line 1" above highest and 1" below lowest fastener location. Find studs behind drywall by tapping wall or using a stud finder. Mark the center of the studs with a vertical line to the right and left of the marked fastener location. Note: Note 2 x 6's must span at least 2 studs side to side. Install 2 x 6's between studs firmly flush with stud front. Make sure all mounting screws will anchor to added lumber. Remark center line and hood bottom on same location as before and tape template on wall as in step 3 above. Mount 2 mounting hooks with wood screws (supplied in mounting hardware kit) on locationsmarked on template, then remove template. Install duct cover ceiling bracket to wall flush to ceiling with drywall anchors supplied. Figure 3. Figure 2 Figure 3 5 Installation Appliance Installation: 11. Install transition on top of hood if removed for shipping. Hang hood on 2 mounting hooks through the rectangular cutouts on back of hood. Level the appliance, using a carpenters level across bottom of hood with leveling screws in mounting hooks or rectangular cutouts. Starting Collar 14. [. . . ] *NORMAL This warranty applies only to products in ordinary household use, and the consumer is responsible for the RESPONSIBILITIES items listed below: OF THE CONSUMER 1. Proper use of the appliance in accordance with instructions provided with the product. Proper installation by an authorized servicer in accordance with instructions provided with the appliance and in accordance with all local plumbing, electrical and/or gas codes. Proper connection to a grounded power supply of sufficient voltage, replacement of blown fuses, repair of loose connections or defects in house wiring. [. . . ]