User manual FRIGIDAIRE RCM5130

[. . . ] Handle air conditioner with care. NOTE: Mounting Hardware Qty. 2 the best way to store unit during winter, or when not in use. ( or Wooden windows) 2 s) 1 weather seals The top rail on your unit may already be installed. window sash seal foam 5 1 4 Top Rail 1 Drill (If pilot holes are needed) Before installing, the top rail must be assembled on the unit. Top Rail 1 How to Install Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. [. . . ] This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained!Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing into the room. Hold the side Panel in one hand and gently pull back the center to free the open end. Slide the free end "I" section of the panel directly into the cabinet as shown in FIG. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet. 6B Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. Carefully close the window behind the top rail of the unit. FIG. 6A INSIDE OUTSIDE INSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. 7B window frame Place the frame lock between the frame extensions and the window sill as shown (FIG. 8B wooden windows: Drive locking screws: A: For wooden windows: Vinyl-Clad windows: NOTE:To prevent B: For Vinyl-Clad windows: NOTE: Before driving the screws, use a drill to drill 5 holes through the holes in the frame lock and frame extensions 3 Installation NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 11 FOAM SEAL After the completion of the installation, please check the machine's lean as shown (FIG. It's necessary for proper condensed water utilization and drainage. 12B H INSIDE OUTSIDE INSIDE H OUTSIDE H=H1-H2 H about Wooden Window Bottom Rail H1 H2 Bottom Rail Vinyl-Clad Window Trim the weather seal with a proper length, peel off the protective backing and plug any gaps if needed Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. [. . . ] It's necessary for proper condensed water utilization and drainage. 12B H INSIDE OUTSIDE INSIDE H OUTSIDE H=H1-H2 H about Wooden Window Bottom Rail H1 H2 Bottom Rail Vinyl-Clad Window Trim the weather seal with a proper length, peel off the protective backing and plug any gaps if needed Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. Remove sash seal from between windows, and unscrew sash lock. [. . . ]