User manual FUJIFILM FINEPIX F410

[. . . ] Getting Ready Using the Camera Advanced Features Settings Software Installation Camera Connection BL00258-201 (1) Warning To prevent fire or shock hazard, do not expose the unit to rain or moisture. CAUTION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] 2 The LCD monitor shows the playback time and a playback progress bar. Rewind Fast forward !G You cannot play back voice memos using multiframe playback. Use the "DISP" button to revert to normal playback. 78 The "r" icon is displayed. !G If the sound is difficult to hear, adjust (P. 80). N Playing back voice memo files N the volume The FinePix F410 can play voice memo files recorded on a FinePix F410 and voice memo files up to 30 seconds long that were recorded on a FUJIFILM digital camera and stored on xD-Picture Card. 79 4 Settings 1 6 ADJUSTING THE MONITOR BRIGHTNESS ADJUSTING THE VOLUME 0 1 2 0 1 0 2 3 N SET­UP Menu Options N The options available in the g menu vary depending on whether "q" or "w" mode is selected. h "q" Still photography mode 0 2 0 1 1 Set the Mode switch to "w". 2 Press the "MENU/OK" button to display the menu on the screen. 0 2 h "u" Movie mode 1 Press "d" or "c" to select "g" OPTION and then press "a" or "b" to select "6LCD" or "VOLUME". 2 Press the "MENU/OK" button. 1 Press "d " or "c " to adjust the monitor brightness or the volume. 2 Press the "MENU/OK" button to confirm the new setting. 4 h "w" Playback mode 80 !G The LCD monitor brightness can be adjusted in "q" and "T". 81 g USING SET­ UP 1 00 13 0 2 2 I SET-UP Menu Options Settings Display Factory Default Explanation This option specifies whether or not an image checking screen (photography results) is displayed after you take a shot. The photographed image is displayed for a few moments and then automatically recorded. Use this option to specify whether the camera's power consumption is reduced and the camera is subsequently switched off automatically when it is not being used. Sets the volume of the tone emitted when the camera controls are used. Sets the volume of the sound emitted when the shutter operates. Use this option to correct the date or time. Use this option to specify whether the LCD monitor is automatically switched ON or OFF when the Mode switch is set to "q". Specifies whether frame numbers are assigned consecutively from previous numbers or begin again. See P. 101 for details. IMAGE DISP. ON/OFF ON POWER SAVE 2 MIN/5MIN/OFF OK OFF/1/2/3 OFF/1/2/3 SET ON/OFF CONT. /RENEW ·/qPC 2 MIN ­ 2 2 ­ ON CONT. · 0 1 0 2 FORMAT )BEEP )SHUTTER DATE/TIME The options in the SET­UP screen can be specified in the "q" Photography, "w" Playback and "T" Movie modes. 1 Press the "MENU/OK" button to display the menu screen. 2 Press "d" or "c" to select "g" OPTION and then press "a" or "b" to select "SET­UP". 3 Press the "MENU/OK" button. 1 Press "a" or "b" to select a menu option and then press "d" or "c" to change the setting. 2 Press "c " or the "MENU/OK" button for "FORMAT", "DATE/TIME" and "q RESET". qLCD FRAME NO. USB MODE /LANG. 4 /ENGLISH/ Select Japanese, English, French or German, Spanish, Chinese as the FRANCAIS/DEUTSCH/ ENGLISH language used for screen display. [. . . ] EXCEPT AS PROVIDED IN SECTION 5 HEREIN, FUJIFILM PROVIDES PRODUCT "AS IS" AND WITHOUT WARRANTIES OF ANY KIND, EXPRESS OR IMPLIED. FUJIFILM SHALL MAKE NO WARRANTY, EXPRESS, IMPLIED OR STATUTORY, AS TO ANY OTHER MATTERS, INCLUDING, BUT NOT LIMITED TO NON-INFRINGEMENT OF ANY COPYRIGHT, PATENT, TRADE SECRET, OR ANY OTHER PROPRIETARY RIGHTS OF ANY THIRD PARTY, MARCHANTABILITY, OR FITNESS FOR ANY PARTICULAR PURPOSE. IN NO EVENT SHALL FUJIFILM HAVE ANY LIABILITY FOR ANY GENERAL, SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL, INCIDENTAL, OR OTHER DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS OR LOST SAVINGS) INCURRED FROM THE USE OF OR INABILITY TO USE PRODUCT EVEN IF FUJIFILM HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. You acknowledge that neither Software nor any part thereof, will be transferred, or exported to any country or used in any manner in violation of any export control laws and regulations to which Software is subject. [. . . ]