User manual FUJIFILM INSTAX SHARE SP-3

[. . . ] Independent JPEG Group (IJG) Licenses This software is based in part on the work of the Independent JPEG Group. 37 • Read “IMPORTANT SAFETY NOTICE” (Page 46) and “Handling the Battery” (Page 53) for safety use. €¢ After reading this User’s Guide, keep it in a safe, easy to find place where you can refer to it if needed. 39 29 Parts Name 3 2 1 8 7 EN 10 4 5 9 6 1 2 3 30 4 Battery remaining LED Film remaining LED Print exit POWER button 5 6 7 8 USB connector cover USB connector Back cover lock REPRINT button 9 10 Battery cover Back cover Before Use • Before using the printer, install the instax SHARE application on your device. [. . . ] — The printer shakes or has been dropped and the film has become misaligned. Solutions ● Do not open the back cover until you have used up the film; otherwise, the rest of the film may be exposed and ruined for use. 1 Do not shake, bend, fold, or press the print. EN A black line is printed on the bottom of the finished print. If this does not solve the problem, load a new film pack. — Contact your FUJIFILM dealer or support center. A vertical line is printed ● The print head is dirty. 45 IMPORTANT SAFETY NOTICE This product has been designed with safety in mind, and to provide safe service when handled correctly and in accordance with the User’s Guide and instructions. It is important that both the product and the INSTAX film are handled properly and used only to print pictures as instructed in this User’s Guide and in the instax SQUARE film instructions. For your ease and safety, please follow what is written in this User’s Guide. It is also a good idea to keep this User’s Guide in a safe, easy to find place where you can refer to it if needed. WARNING If the printer (or batteries) becomes hot, emits smoke or a burnt smell or otherwise seems abnormal, immediately remove the batteries. Faults of this nature could start a fire and cause burns. (Take particular care to avoid burns when removing the batteries or pull out the USB cable. If the printer will be left unused for a long period (because you are traveling, etc), remove the batteries, disconnect the AC power adapter and unplug the USB cable. Do not move the printer while the USB cable is still connected to it. Doing so could damage the USB cable and cause a fire or electric shock. Keep out of the reach of small children. This product could cause injury in the hands of a child. Do not cover or wrap the printer or the AC power adapter in a cloth or blanket. This can cause heat to build up and distort the casing or cause a fire. When using the printer, make sure that the battery cover is attached; otherwise, you may be injured. [. . . ] Keep a fully charged spare battery in a warm place and exchange as necessary, or keep the battery in warm place and insert it in the printer only when shooting. Do not place the battery in direct contact with hand warmers or other heating devices. – â–  Charging the Battery Charge the battery using the supplied USB cable. Charging times will increase at ambient temperatures below +10 °C (+50 °F) or above +35 °C (+95 °F). [. . . ]