User manual FUJITSU SIEMENS AMILO DESKTOP SI 3535 FIRST-TIME SETUP

[. . . ] Com/support All rights reserved, including intellectual property rights. Technical data subject to modifi cations and delivery subject to availability. Any liability that the data and illustrations are complete, actual or correct is excluded. Designations may be trademarks and/or copyrights of the respective manufacturer, the use of which by third parties for their own purposes may infringe the rights of such owner. [. . . ] Remove all power plugs from the grounded mains outlets. connect all the cables to the device and the external devices. Please make sure that you always observe the safety notes provided in "Important information", Page 3 . plug all data communication cables into the appropriate sockets. Plug all power cables into the grounded mains outlets. Remove all power plugs from the grounded mains outlets. unplug all data communication cables from the appropriate sockets. Disconnect all of the cables from the device and from the external devices. Follow the instructions contained in the monitor manual to prepare the monitor for operation (e. Depending on the expansion stage of your machine and your monitor, you can also connect the data cable to the DVI interface. Plug the monitor power cable into the grounded mains outlet. The LX300 Wireless Keyboard Set with wireless mouse and keyboard is supplied with your machine. digital radio technology frees you from cumbersome cables. Comply with the safety information in the safety manual and in the operating instructions for the "AMILO Desktop". A symbol in the battery compartment shows you which way round to insert the batteries. To save power, set the on/off switch on the underside of the mouse to "OFF" when you are not going to use the mouse for an extended period. A symbol in the battery compartment shows you which way round to insert the batteries. Move the receiver in the direction of the arrow to take it out of the keyboard. Plug the receiver into a free USB port on your computer. Normally a radio connection code is generated automatically and the Keyboard Set is then immediately ready for operation. When the connection has successfully been established the LED on the receiver lights up green. The LEDs on the keyboard and mouse light up red if the battery voltage falls below 2. [. . . ] the display flashes yellow: The hard disk is being accessed. The display remains unlit: The machine is not connected to the mains or is not ready for operation. If the machine is ready for operation, it can be switched on at the on/off switch. A memory card reader is incorporated in the front of your machine. [. . . ]