User manual FUJITSU SIEMENS AMILO LI GETTING STARTED

[. . . ] Any technical problems or other questions that you need help with? please contact: · Our Hotline/Help Desk (see Help Desk List) or visit "www. Your sales office Additional information is contained in the Help Desk list and the "Warranty" manual. The "Warranty" manual can be found on your notebook under Start or on the "Drivers & Utilities" CD/DVD or on our website. [. . . ] Two different mains adapters are available for this computer. Use only the mains adapter supplied with your computer. please refer to the instructions in "Safety information" , Page 3. The power cable supplied conforms to the requirements of the country in which you purchased your notebook. Make sure that the power cable is approved for use in the country in which you intend to use it. The mains adapter's power cable must only be connected to a mains socket if the notebook is connected to the mains adapter. Make sure that the rated current of the mains adapter is not higher than that of the power system to which you connect it (see technical data for the mains adapter). connect the mains adapter cable (1) to the DC jack (DC IN) on the notebook. Plug the power cable (2) into the mains adapter. Plug the power cable (3) into a mains outlet. When you switch your notebook on for the first time, the supplied software is installed and configured. Due to the fact that this installation procedure must not be interrupted, you should set aside enough time for it to be fully completed and connect the notebook to the mains outlet using the mains adapter. During installation, the notebook must only be rebooted when you are requested to do so!Your operating system is pre-installed on the hard disk to facilitate the procedure when you use your notebook for the first time. switch the notebook on (see "Switching on the Notebook" , Page 7). During installation, follow the on-screen instructions. Consult the operating system manual if anything is unclear about the requested input data. If a Windows operating system is installed on your notebook, you will find additional information on the system as well as the drivers, help programs, updates, manuals, etc. On your notebook or on the "Drivers & Utilities" CD/DVD or on our website (see "Information sources", Page 2). From the Windows Start menu, by clicking on Start ­ Shut Down ­ Shut down ­ OK). If the notebook is not switched off automatically, press the ON/OFF switch (1) for approx. Close the LCD screen (1) so that it locks into place. [. . . ] The BIOS Setup Utility can also be used to assign passwords. The "EasyGuide" manual explains how to open and close the BIOS Setup Utility. Refer to the safety information in the "Safety" manual when connecting or disconnecting cables. If a fault occurs, try to correct it as described. [. . . ]