User manual FUJITSU SIEMENS SCENIC 365

[. . . ] All rights, including rights of translation, reproduction by printing, copying or similar methods, even of parts are reserved. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. Your mainboard is available in different configuration levels. Depending on the configuration chosen, some of the hardware components described may not be available on your mainboard. [. . . ] PS/2 keyboard port, purple Serial interface, turquoise Audio input (Line in), light blue PS/2 mouse port, green Parallel port/Printer, burgundy The LAN controller is equipped with a 2 KB transmission and receiving buffer (FIFO) and supports WOL function through Magic Packet. An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for the ultra ATA/66 or ultra ATA/100 mode. If you want to use the internal connection for the audio front panel for the front side of the system, then proceed as follows: Remove all plug-in jumpers from the audio front panel connection. If you connect audio devices on both the front and the back of the system, you can only use the connections Line out and Microphone once each. If you have connected audio devices to both Line out connections, only the connection on the front of the system is active. If you have connected audio devices to both Microphone connections, only the connection on the back of the system is active. This makes it possible to connect 4 or 6 loudspeakers, and therefore to achieve a better surround-sound effect. drivers A corresponding driver must be installed for the 2 , 4 or 6-channel audio mode. If the drive is not installed yet, proceed as described in the chapter "Add-on modules / Upgrading", in the section "Drivers". Connecting loudspeakers The number of loudspeakers connected should match the number of audio channels you select in the driver software. Line-In is converted into the Rear-Out function with the 4-channel configuration. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very thin layer of heat conducting paste. Heat conducting pads can only be used once. If you remove the heat sink, you must clean it and apply new heat conducting paste before you remount it. Please note that, depending on the heat sink used, different heat sink mounts are required on the mainboard. Depending on the configuration variant, you must pull a protective foil off the heat sink or coat the heat sink with heat conducting paste before fitting it. Secure the heat sink - depending on the model - with four screws or push it into the mounts. A current list of the memory modules recommended for this mainboard is available on the Internet at: www. At least one memory module must be installed. Memory modules with different memory capacities can be combined. DDR-DRAM memory modules must meet the PC2700 or PC3200 specification. [. . . ] invalid System Configuration Data In the Advanced menu of the BIOS Setup set the entry Reset Configuration Data to Yes. Invalid System Configuration Data - run configuration utility Press F1 to resume, F2 to Setup This error message may be displayed if the machine was switched off during system start-up. Keyboard controller error Connect another keyboard or another mouse. If the message is still displayed, please contact your sales outlet or customer service centre. [. . . ]