User manual FUJITSU SIEMENS SCENIC C620 (I915GV)-D1784

[. . . ] Microsoft, MS, MS-DOS und Windows sind eingetragene Warenzeichen der Microsoft Corporation. PS/2 und OS/2 Warp sind eingetragene Warenzeichen von International Business Machines, Inc. Alle weiteren genannten Warenzeichen sind Warenzeichen oder eingetragene Warenzeichen der jeweiligen Inhaber und werden als geschützt anerkannt. Copyright ã Fujitsu Siemens Computers GmbH 2001 Alle Rechte vorbehalten, insbesondere (auch auszugsweise) die der Übersetzung, des Nachdrucks, der Wiedergabe durch Kopieren oder ähnliche Verfahren. [. . . ] Please observe the safety information provided in the "Important notes" chapter in the device's operating manual. Incorrect replacement of the lithium battery may lead to a risk of explosion. It is therefore essential to observe the instructions in the "Add-on modules" - "Replacing the lithium battery" section. A26361-D1218-Z120-4-7419 English - 1 Important notes The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installation information in the Operating Manual or Technical Manual for the receiving device. Connecting cables for peripherals must be adequately shielded to avoid interference. ! i Components can become very hot during operation. Ensure you do not touch components when making extensions to the system board. The warranty is invalidated if the device is damaged during the installation or replacement of system expansions. Information on which system expansions you can use is available from your sales outlet or the customer service centre. Information about boards To prevent damage to the system board or the components and conductors on it, please take great care when you insert or remove boards. Take great care to ensure that extension boards are slotted in straight, without damaging components or conductors on the system board, or any other components, for example EMI spring contacts. Be especially careful with the locking mechanisms (catches, centring pins etc. ) when you replace the system board or components on it, for example memory modules or processors. To restore the old system BIOS you need a Flash BIOS Diskette (please call our customer service centre). On Off The System BIOS executes from floppy drive A: and the inserted "Flash-BIOSDiskette" restores the System BIOS on the system board. Normal operation (default setting). Write protection for floppy disks - switch 3 Switch 3 is used to define whether floppy disks can be written or deleted in the floppy disk drive. To write and delete floppy disks, the write-protection in BIOS Setup must be disabled (in menu Security, the field Diskette Write must be set to Enabled). On Off The floppy disk drive is write-protected. Floppy disks can be read, written and deleted (default setting). 8 - English A26361-D1218-Z120-4-7419 CNR Add-on modules Add-on modules ! Exit Suspend mode, switch off the device and remove the power plug from the mains supply, before carrying out any of the procedures described in this chapter!Even when you have switched off the device, parts (e. g. memory modules, AGP and PCI extension boards) are still supplied with power. The voltage indicator LED will glow if this is the case. All AGP and PCI slots support 3. 3 V main and auxiliary voltages. 6 5 4 3 2 DIMM 3 DIMM 2 DIMM 1 AGP / GPA PCI 4 PCI 1 1 PCI 2 PCI 3 PCI 5 9 8 1= 2= 3= 4= 5= Socket for processor with heat sink Voltage indicator LED Location bank 1 for main memory Location bank 2 for main memory Location bank 3 for main memory 6= 7= 8= 9= Lithium battery CNR slot shared with PCI slot PCI slots 1, 2, 3, 4, 5 AGP/GPA slot CNR 7 A26361-D1218-Z120-4-7419 English - 9 Add-on modules Installing and removing processors 3 2 4 5 1 A Ê Ê Ê Pull the lever in the direction of the arrow (1) and lift it as far as it will go (2). Remove the old processor from the socket (3). [. . . ] Hävitä käytetty paristo valmistajan ohjeiden mukaisesti. VARNING Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion. [. . . ]