User manual FUJITSU SIEMENS SCENICO N320 (V8M800)

[. . . ] PS/2 and OS/2 Warp are registered trademarks of International Business Machines, Inc. All other trademarks referenced are trademarks or registered trademarks of their respective owners, whose protected rights are acknowledged. Copyright ã Fujitsu Siemens Computers GmbH 2002 All rights, including rights of translation, reproduction by printing, copying or similar methods, in part or in whole, are reserved. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. [. . . ] If you pass the system board on to third parties, you should pass this manual on with it. You cannot access the system board components without first opening the system. How to dismantle and reassemble the system is described in the Operating Manual accompanying the system. ! Please observe the safety information provided in the "Important notes" chapter in the system's operating manual. Incorrect replacement of the lithium battery may lead to a risk of explosion. It is therefore essential to observe the instructions in the "Add-on modules" "Replacing the lithium battery" section. Components can become very hot during operation. Ensure you do not touch components when making extensions to the system board. There is a danger of burns! A26361-D1332-Z120-1-7419 English - 1 Important notes The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installation information in the Operating Manual or Technical Manual for the receiving device. Connecting cables for peripherals must be adequately shielded to avoid interference. i The warranty is invalidated if the system is damaged during the installation or replacement of system expansions. An onboard controller developed by Fujitsu Siemens Computers controls the temperature and system monitoring. The following functions are supported: Temperature monitoring: Measurement of the processor and the system temperature with an onboard temperature sensor. Temperature control: The temperature is controlled by adjusting the fan speed and/or by reducing the clock frequency of the processor. The clock frequency of the processor is dependent upon the setting in the BIOS Setup. Temperature-dependent processor speed control enables a reduced fan speed, decreasing noise. Fan monitoring: Fans which have been removed, blocked or sticky fans are detected. Blocked or sticky fans are operated with 12 V pulse voltage. If the system has a monitored fan removed while the system is switched off this is indicated by the message LED when the system is switched on again and processed by the BIOS or the application. Fan control: With the exception of the auxiliary fan (AUX), the fans are regulated according to temperature. Sensor monitoring: The removal of, or a fault in, a temperature sensor is detected. Should this happen all fans monitored by this sensor run at maximum speed, to achieve the greatest possible protection of the hardware. [. . . ] Carefully remove the memory module from the compartment (2). A26361-D1332-Z120-1-7419 English - 11 Add-on modules Installing network board with WOL Ê Ê Install the network board as described in the operating manual for your unit. Push the WOL cable onto the WOL plug connector of the system board. To use the WOL functionality of a network board the power supply must provide a 5 V auxiliary voltage of at least 1 A. If the system board was not already incorporated in a device when you bought it you must check whether your power supply can provide the auxiliary voltage. [. . . ]