User manual FUJITSU AOYG 18LAC2.UE

[. . . ] 49 U7000 ENGLISH USER’S MANUAL SAFETY PRECAUTION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to “dangerous voltage” and to prevent from a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to important operating and maintenance (servicing). danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. [. . . ] On “Scan Mode” item, you can select “Auto Scan” to make a blind scan , “Preset Scan” to scan all preset transponders or “NIT Search” (the NIT (Network Identification) will be identified and the receiver will automatically search all the TP of this network). In the lower part of the window the progress of scanning and the found channels are displayed. Press [Exit] to cancel or finish the scanning and saving the found channels. 2 When you enter “TP Scan” menu a window like the one beside will be displayed (OSD 51): ] to select the satellite 1. On “Satellite” item, press [ you want to scan or press [OK] to open the satellite list for selection. On “TP Index” item use [ ] to select the desired transponder. If any of the TP of the list have tuned and stored channels into the receiver, the following three options “Frequency”, “Symbol Rate” and “Polarity” will not be able to be edited. It means that the parameters cannot be modified by error neither loosing the stored channels when any value of the data base is changed. In case of any value, for example the Symbol Rate of a TP, has been modified by the provider and the receiver has these channels tuned, the TP must be deleted (it will delete all the channels of this TP), create it again with the correct data, and to carry out a new search of the TP. In this item you can also add, delete or delete all TP. - Press [Red] button to add a new TP (OSD 52). You have to set the parameters of “TP Frequency”, “Symbol Rate” and “Polarity” for this new transponder. Therefore use the number buttons of the RCU. The available range are “3000~13450 MHz” and “1000~45000KS/s”. - Press [Green] button to delete the current TP. A safety question will be displayed for confirmation to delete the current transponder or not (OSD 53). If you select “Yes”, the current transponder will be deleted and the total number of transponders will be reduced. - Press [Yellow] button to delete all TP. A safety question will be displayed for confirmation to delete all transponders or not. For transponders you also can use number buttons to modify the parameters of “TP Frequency” and “Symbol Rate” or [ ] to change the value directly. €Polarity” and “Scan Mode” are used for setting scans conditions. Search channels of the TP: Selecting this option, a new window appears, where you can configure the following parameters (OSD 54): - On “FTA Only” item, press [ ] to select scanning of all channels or just scanning of free channels. [. . . ] In case that you play a playlist, it will play all the fi les one by one. 2 Inside this menu you will be able to find the options “Record Type”*, “Timeshift Size”*, “Auto Timeshift”*, “Jump Step Value”*, “Disk” and “Hard disk formatting” (OSD 115). * This function will only be available in models with PVR ready functionability DVR MANAGEMENT 7. RECORD TYPE* In this option, you can configure the video format of the recordings. [. . . ]