User manual FUJITSU AOYG09KXCA

[. . . ] To check whether your wireless router complies with the network security standards listed above, refer to the operation manual. For user registration and setup information, refer to Setting Manual attached with the product. For the latest version of the Wireless LAN (WLAN) control manuals, refer to the following web site. Human sensor for energy saving setting If timer settings are done from mobile application and from wireless remote controller, both timer settings will be active. [. . . ] NOTE: Setting will not be changed if invalid numbers or setting values are selected. Room temperature control for indoor unit sensor Indoor unit fan control for energy saving for cooling Select appropriate intervals for automatically cleaning the air filter according to environmental conditions and the conditions of use. Short interval (Approximately once every 3 days) 2) Left/right swing operation range Select the operation range of the left/right swing according to the installation condition. 3) Room temperature control for indoor unit sensor Depending on the installed environment, correction of the room temperature sensor may be required. Select the appropriate control setting according to the installed environment. The temperature correction values show the difference from the Standard setting "00" (manufacturer's recommended value). 4) Auto restart Enables or disables automatic restart after a power interruption. NOTE: Auto restart is an emergency function such as for power outage etc. Do not attempt to use this function in normal operation. Be sure to operate the unit by remote controller or external device. 5) Remote controller custom code (Only for wireless remote controller) The indoor unit custom code can be changed. 6) Indoor unit fan control for energy saving for cooling Enables or disables the power-saving function by controlling the indoor unit fan rotation when the outdoor unit is stopped during cooling operation. 00: When the outdoor unit is stopped, the indoor unit fan operates continuously following the setting on the remote controller. 01: When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low speed. As the factory setting, this setting is initially activated. Set to "00" or "01" when connecting a remote controller that cannot set the Fan control for ener- gy saving function or connecting a network converter. To confirm if the remote controller has this setting, refer to the operating manual of each remote controller. (Set this when the dual fan airflow is too strong or week. (Set this when the dual fan airflow hits furniture or does not reach the intended area. 9) Maintenance indicator switchover Display/hide the indicator that shows when to clean the dust box or the plasma air clean unit. To interconnect the air conditioner and the wireless remote controller, assignment of the custom code for the wireless remote controller is required. NOTE: Air conditioner cannot receive a signal if the air conditioner has not been set for the custom code. [. . . ] Capacity compensation rate for pipe length and height difference Indoor unit is higher than outdoor unit *1 Indoor unit is lower than outdoor unit *2 NOTE: Values mentioned in the table are calculated based on the maximum capacity. Indoor unit is higher than outdoor unit *1 Indoor unit is lower than outdoor unit *2 Indoor unit is higher than outdoor unit *1 Indoor unit is lower than outdoor unit *2 Capacity compensation rate for pipe length and height difference OUTDOOR UNIT AOYG09, 12KXCA Octave band sound pressure level, dB: (0 dB=0. Octave band sound pressure level, dB: (0 dB=0. Octave band sound pressure level, dB: (0 dB=0. [. . . ]