User manual FUJITSU C1320D

[. . . ] cotton. book Page 1 Wednesday, August 17, 2005 1:20 PM Copyright Copyright and Trademark Information Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document; however, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. MS, MS-DOS, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. [. . . ] Try to use your integrated pointing device to restart your system. (See Device Ports on page 44 for more information) Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD, drive designations are automatically adjusted. Verify your password and security settings. Eject the floppy disk and set it to write enable. (See Preparing a Disk for Use on page 38 for more information) Eject floppy disk, check orientation and re-insert. (See Ejecting a Disk on page 38 for more information) Remove and re-install your floppy disk drive. Verify your password and security settings. Port Replicator AC adapter is not plugged in. Notebook is not properly seated in the Port Replicator. Remove and re-dock your LifeBook notebook. 51 cotton. book Page 52 Wednesday, August 17, 2005 1:20 PM LifeBook C Series Notebook - Section Five Problem Possible Cause Possible Solutions You have installed an external keyboard or mouse, and it does not seem to work. (continued) Your operating system software is not set up with correct software driver for that device. Your mouse or keyboard is connected to the wrong PS/2 port on the optional Port Replicator. Your operating system software is not setup with correct software driver for that device. Your system has crashed. Check your device and operating system documentation and activate the proper driver. Plug the mouse into the PS/2 Mouse port and the external keyboard into the PS/2 Keyboard port. (See Docking Port on page 45 for more information) Check your device and operating system documentation and activate the proper driver. I You have connected an external keyboard or a mouse and it seems to be locking up the system. Memory Problems Your Power On screen, or Main menu of the BIOS setup utility information, does not show the correct amount of installed memory. Modem Problems Messages about modem operation. Your memory upgrade module is not properly installed. You have a memory failure. Remove and re-install your memory upgrade module. (See Memory Upgrade Module on page 42 for more information) Check for Power On Self Test (POST) messages. [. . . ] IP address consists of the subnet address and the address of each computer. Subnet mask defines how many bits of IP address comprise the subnet address. The same value shall be set among computers communicating with each other. TCP/IP (Transmission Control Protocol/Internet Protocol) A standard protocol of the Internet. [. . . ]