User manual FUJITSU N5010

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual FUJITSU N5010. We hope that this FUJITSU N5010 user guide will be useful to you.

Lastmanuals help download the user guide FUJITSU N5010.


Mode d'emploi FUJITSU N5010
Download
Manual abstract: user guide FUJITSU N5010

Detailed instructions for use are in the User's Guide.

[. . . ] cygnus. book Page 1 Tuesday, September 30, 2003 4:22 PM Copyright Copyright Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Specifications are subject to change without notice. [. . . ] *Parity Check 1 nnnn Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays ????. This is a potentially data-destroying failure. Contact your support representative. 57 cygnus. book Page 58 Tuesday, September 30, 2003 4:22 PM LifeBook N Series User's Guide *Parity Check 2 nnnn Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays ????. This is a potentially data destroying failure. #*Press <F1> to resume, <F2> to SETUP Displayed after any recoverable error message. Press the [F1] key to continue the boot process or the [F2] key to enter Setup and change any settings. #*Previous boot incomplete ­ Default configuration used Previous Power On Self Test did not complete successfully. The Power On Self Test will load default values and offer to run Setup. If the previous failure was caused by incorrect values and they are not corrected, the next boot will likely fail also. If using the default settings does not allow you to complete a successful boot sequence, you should turn off the power with the power/suspend/ resume button and contact your support representative. *Real time clock error Real-time clock fails BIOS test. *Shadow RAM Failed at offset: nnnn Shadow RAM failed at offset nnnn of the 64k block at which the error was detected. You are risking data corruption if you continue. nnnn Shadow RAM Passed Where nnnn is the amount of shadow RAM in kilobytes successfully tested. *System battery is dead ­ Replace and run SETUP The BIOS CMOS RAM memory hold up battery is dead. This is part of your BIOS and is a board mounted battery which requires a support representative to change. You can continue operating but you will have to use setup utility default values or reconfigure your setup utility every time you turn off your LifeBook notebook. This battery has an expected life of 2 to 3 years. [. . . ] The same value shall be set among computers communicating with each other. TCP/IP (Transmission Control Protocol/Internet Protocol) A standard protocol of the Internet. Wi-Fi Indicates that the interconnectivity test of the organization which guarantees the compatible connection of wireless LAN (Wi-Fi Alliance) has been passed. 104 cygnus. book Page 105 Tuesday, September 30, 2003 4:22 PM W I r e l e s s L A N U s e r 's G u id e IP address information IP addressing is much more complicated than can be briefly explained in this document. You are advised to consult with your network administrator for additional information. If IP address is unknown, set IP address as follows: If you have an access point (DHCP server) on the network, set the IP address as follows: Windows 2000: [Obtain an IP address automatically] Windows XP: [Obtain an IP address automatically] A DHCP server is a server that automatically assigns IP addresses to computers or other devices in the network. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FUJITSU N5010

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual FUJITSU N5010 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag