User manual FUJITSU N6010

[. . . ] Copyright Copyright and Trademark Information Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. The absence of a product or service name, slogan, or logo does not constitute a waiver of any trademark or other intellectual property rights relating to that name, slogan, or logo owned by Fujitsu Computer Systems Corporation, its parent, subsidiaries, and affiliated companies. [. . . ] (See Power Sources on page 23 for more information) You are operating on battery power only and have ignored a low battery alarm until the batteries are all at the dead battery state and your machine has gone into Dead Battery Suspend mode. Your power adapter has failed or lost its power source. You have a battery failure. Make sure the adapter is plugged in and the outlet has power. Verify the condition of the batteries using the Status Indicator panel, and replace or remove any batteries that are shorted. (See Status Indicator Panel on page 14 for more information) Replace the battery with a charged one or install an AC adapter. Verify that the batteries are properly connected by re-installing them. Your LifeBook notebook will not work on battery alone. The installed batteries are dead. The batteries are improperly installed. 57 LifeBook N Series User's Guide Problem Possible Cause Possible Solutions Your LifeBook notebook will not work on battery alone. (continued) The batteries seem to discharge too quickly. Your installed batteries are faulty. Verify the condition of the batteries using the Status Indicator panel and replace or remove any batteries that are shorted. (See Status Indicator Panel on page 14 for more information) Use both the primary battery and an optional second battery and/or use a power adapter for this application when at all possible. You are running an application that uses a great deal of power due to frequent hard drive or DVD/CD-ROM access, or use of a modem or LAN PC card. The power savings features may be disabled. The brightness is turned all the way up. The batteries have been exposed to high temperatures. The batteries are too hot or too cold. Check the power management and/or setup utility settings in the Power Savings menu and adjust according to your operating needs. The higher the brightness the more power your display uses. Restore the notebook to normal operating temperature. The Status Indicator panel Charging icon will flash when the battery is out of operating range. Shutdown and Startup Problems The Power and Suspend/ Resume button does not work. The Power and Suspend/ Resume button is disabled from the Power -> Advanced submenu of the setup utility. You did not hold the button in long enough. There may be a conflict with the application software. The system powers up and displays power-on information, but fails to load the operating system. The boot sequence settings of the setup utility are not compatible with your configuration. You have a secured system requiring a password to load your operating system. [. . . ] IP address consists of the subnet address and the address of each computer. Subnet mask defines how many bits of IP address comprise the subnet address. The same value shall be set among computers communicating with each other. TCP/IP (Transmission Control Protocol/Internet Protocol) A standard protocol of the Internet. [. . . ]