User manual FUJITSU P1032

[. . . ] B5FH-4881-01EN-00. book Page 1 Thursday, January 17, 2002 10:43 AM Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. [. . . ] The wrong drive designator was used by an application when a bootable CD-ROM was used to start the notebook. Security is set so your operating system cannot be started without a password. Keyboard or Mouse Problems The built-in keyboard does not seem to work. The notebook has gone into Suspend mode. Eject the floppy disk and set it to write enable. (See Preparing a Disk for Use on page 44 for more information) Eject floppy disk, check orientation and re-insert. (See Ejecting a Disk on page 44 for more information) Remove and re-install your floppy disk drive. Verify your password and security settings. Revise BIOS settings to set both Primary Master and Primary Slave correctly. (See BIOS Setup Utility on page 23 for more information) Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD, drive designations are automatically adjusted. Verify your password and security settings. Push the Suspend/Resume/Power On button. 40 B5FH-4881-01EN-00. book Page 41 Thursday, January 17, 2002 10:43 AM Tro ublesho oting Problem Possible Cause Possible Solutions The built-in keyboard does not seem to work. (continued) You have installed an external keyboard or mouse, and it does not seem to work. Your application has locked out your keyboard. Try to use your integrated pointing device to restart your system. If this fails, turn your system off using the Power Off button located on the back of the system. Wait 10 seconds or more, then turn the system back on. (See Device Ports on page 35 for more information) Check your device and operating system docu-mentation and activate the proper driver. Check your device and operating system documentation and activate the proper driver. Your external device is not properly installed. The operating system software is not set up with the correct software driver for that device. Your operating system software is not setup with the correct software driver for that device. This happens due to the design specifications of the Quick Point device. You have connected an external keyboard or a mouse and it seems to be locking up the system. When the system is slightly inclined and the QuickPoint device has been worked with slowly for several seconds, the cursor slowly moves across the screen when you are not using it. Memory Problems Your Power On screen, or Main menu of the BIOS setup utility information, does not show the correct amount of installed memory. Modem Problems Messages about modem operation. USB Device Problems You have installed a USB device but your LifeBook notebook does not recognize the device, or the device does not seem to work properly. If this occurs, wait until the cursor stops moving; it should then work properly. Your memory upgrade module is not properly installed. [. . . ] Cette certification signifie que l'équipement satisfait certaines normes de protection, d'exploitation et de sécurité des réseaux de télécommunications. Le département ne garantit pas le fonctionnement de l'équipement à la satisfaction de l'utilisateur. La série LifeBook notebook e possède un modem interne conforme aux normes de certification d'Industrie Canada pour protéger les réseaux de télécommunications et satisfaire aux normes de sécurité. Avant de connecter cet équipement à une ligne téléphonique, l'utilisateur doit vérifier s'il est permis de connecter cet équipement aux installations de télécommunications locales. [. . . ]