User manual FUJITSU POINT 510

[. . . ] Point 510 Pen Tablet User's Guide Fujitsu Personal Systems, Inc. has made every effort to ensure the accuracy and completeness of this document; however, because ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes herein. Point 510 is a trademark of Fujitsu Personal Systems, Inc. [. . . ] The procedures are outlined briefly in the following table: Point 510 Pen Tablet Setup Suspend/Resume Suspend and Resume Procedure To suspend, press the Power button once. On/Off To suspend, use power management software to select Suspend mode (do not press the Power button). To resume, press the Power button once. Entering Suspend Mode ­ Suspend/Resume Power Button 2 If your Point 510 pen tablet is set up so that the Power button suspends and resumes operation you can take the following steps to put the pen tablet in Suspend mode: 1. The Point 510 pen tablet emits a double beep (if the speaker is on). Note that your system may take a few seconds to suspend operation depending on how it is configured. If the pen tablet does not appear to be responding, do not press the button repeatedly or more firmly. 2-6 Using the Point 510 Pen Tablet Any programs you are running are stopped, data is preserved, and the system enters a low-power state, called Suspend mode. For more information, see "Power States" on page 2-2. When the light is blinking once every 4 seconds, the Point 510 pen tablet is in suspend mode. You can press the Power button once to resume the Fully On state. Entering Suspend Mode ­ On/Off Power Button 2 If your Point 510 pen tablet Power button is set up to turn the pen tablet on or off, then to suspend operation you must use a suspend/resume software program designed for this purpose. Ask the computer professional at your site who maintains the Point 510 pen tablets about what software to use. Run the suspend command from a power management program on your Point 510 pen tablet. The Point 510 pen tablet emits a double beep (if the speaker is on). Any programs you are running are stopped, data is preserved, and the system enters a low-power state, called suspend mode. For more information, see "Power States" on page 2-2. When the light is blinking once every 4 seconds, the Point 510 pen tablet is in suspend mode. The Power button temporarily serves as a Suspend/Resume button. Press it once to resume the Fully On state. Resuming Operation 2 Resuming operation on your Point 510 pen tablet is the same whether your pen tablet is set up to suspend using the Power button or using a software program. To resume operation: · Press the Power button only once. (Be careful to avoid pressing the Power button again during the resume process. ) The Point 510 pen tablet returns to the Fully On state and operation resumes. The screen might flicker during the resume process. Resuming might take several seconds as data is read back in. You can continue using the pen tablet as soon as operation resumes. [. . . ] To avoid damage to heat-sensitive components, the pen tablet enters suspend mode if it gets too hot. The Point 510 pen tablet cannot resume operation until it cools off to a predetermined temperature. Move the pen tablet to a cooler location and prevent direct sunlight from shining on it. 3-4 Care and Maintenance Display Screen Is Blank or Difficult to Read 3 The display screen can be adjusted using the hotpads. For details on using these controls, see "Using Hotpads" on page 2-5. [. . . ]