User manual FUJITSU S2010

[. . . ] Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document; however, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. [. . . ] The primary battery is installed but is faulty. Check the Status Indicator Panel to determine the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) Install a charged battery or a Power adapter. (See PC Cards on page 43 for more information) Close the application and restart your notebook. See your software documentation and activate the correct driver. See your PC Card documentation to determine the required I/O address. (See BIOS Setup Utility on page 29 for more information) Check all I/O addresses located within the BIOS setup utility and any other installed hardware or software to make sure there are no duplications. Use the Status Indicator panel to verify the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) If a battery is indicating a short, remove that battery and operate from another power source or replace that battery. The battery or batteries are low. Check the Status Indicator Panel to determine the presence and condition of the batteries. (See Status Indicator Panel on page 11 for more information) Use a Power adapter to operate until a battery is charged or install a charged battery. The power adapter (AC or auto/airline) is not plugged in properly. The Power adapter (AC or auto/airline) has no power from the AC outlet, airplane seat jack, or the car's cigarette lighter. The Power adapter (AC or auto/airline) is faulty. Verify that your adapter is connected correctly. (See Power Sources on page 27 for more information) Move the AC cord to a different outlet, check for a line switch or tripped circuit breaker for the AC outlet. If you are using an auto/airline adapter in a car make sure the ignition switch is in the On or Accessories position. Try a different Power adapter or install a charged optional second battery. 59 LifeBook S2000 Series ­ Section Five Problem Possible Cause Possible Solutions Your LifeBook notebook turns off all by itself. The power management parameters are set for auto timeouts which are too short for your operating needs. Press any button on the keyboard, or move the mouse to restore operation. If that fails, push the Power/Suspend/Resume button. Check your power management settings, or close your applications and go to the Power Savings menu of the setup utility to adjust the timeout values to better suit your needs. Install a power adapter and then push the Power/ Suspend/Resume button. (See Power Sources on page 27 for more information) You are operating on battery power only and have ignored a low battery alarm until the batteries are all at the dead battery state and your machine has gone into Dead Battery Suspend mode. You have a battery failure. Verify the condition of the batteries using the Status Indicator panel, and replace or remove any batteries that are shorted. (See Status Indicator Panel on page 11 for more information) Make sure the adapter is plugged in and the outlet has power. [. . . ] Perform the following steps. Click [PRISM 11Mbps Wireless LAN for Windows]. Click [Change/Remove]. A window appears asking you if you really want to remove the driver. When the driver is removed, a window appears showing that the driver has been removed. Close [Add/Remove Programs] and [Control Panel]. [. . . ]