User manual FUNAI CMWV405

[. . . ] Owner's Manual Video Cassette Recorder If you need additional operating assistance after reading this owner's manual or to order replacement accessories, please call RF Output Channel If channel 3 is already occupied for broadcasting, Hint ) Set your TV to channel 4. · The RF output channel 2) Insert a pre-recorded tape into this unit. does not change when 3) Press [PLAY B] once. you adjust tracking during 4) After a few seconds, hold [PLAY B] on the unit for 3 seconds. [. . . ] · Make sure the power is turned on. · Make sure the timer recording is set correctly. · Make sure the VCR clock is set correctly. · Make sure the tape has a record tab. If needed, cover the hole with adhesive tape. Cannot go into Recording mode. A Note about Recycling Playback picture is partially noisy. · Adjust tracking control for a better picture by pressing [CHANNEL ]. This product's packaging materials are Cannot view a tape but the audio · Head cleaning may be necessary. Refer to "Auto Head Cleaning" on recyclable and can be reused. dispose of any materials in accordance · Make sure the VCR is not in the Menu mode. · Change the RF output channel to CH4. Then select the same Batteries should never be thrown away channel on the TV. Avoid the Hazards of Electrical Shock or incinerated but disposed of in accord· Fine tune your TV. and Fire ance with your local regulations concern- TV programs cannot be seen · Re-check the ANT-IN and ANT-OUT connections. · Do not handle the power cord with wet ing chemical wastes. · Press [VCR/TV] on the remote control so that the VCR/TV indicator on the unit disappears. No operation from the infrared · Make sure the power plug is connected to an AC outlet. Note to the Cable TV System Installer · Do not pull on the power cord when Remote Control. · Check batteries in remote control. This reminder is provided to call the Video or color fades in and out when · You cannot copy a copyrighted video tape. You are experiencing Grasp it by the plug. Cable TV system installer's attention to making a copy of a video tape. Article 820-40 of the NEC that provides Moisture Condensation Warning guidelines for proper grounding and Specifications Moisture condensation may occur inside in particular, specifies that the cable Video Heads : Four Heads Power requirement : 20V, 60Hz the unit when it is moved from a cold ground should be connected to the Operating temperature : 4°F~04°F Power consumption : 4 Watts place to a warm place, or after heating grounding system of the building, as (5°C~40°C) Dimensions : W 4-3/6" (360mm) a cold room or under conditions of high close to the point of cable entry as posConverter output : VHF Channel 3 or 4 H 3-5/8" (92mm) humidity. [. . . ] This warranty shall not be extended to any other person or transferee. This warranty is void and of no effect if any serial numbers on the product are altered, replaced, defaced, missing or if service was attempted by AN UNAUThORIZeD seRvICe CeNTeR. This limited warranty does not apply to any product not purchased and used in CANADA. This warranty only covers failures due to defects in material or workmanship which occurs during normal use. [. . . ]