User manual FUNAI F4819CUS

[. . . ] The caution marking is located on the rear of the cabinet. THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. IMPORTANT SAFEGUARDS 1. Read instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. [. . . ] (It will show up momentarily then disappear. ) · Recording stops when the display shows 0:00. · Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120). · If the tape runs out before the end time, the unit will switch to the stop mode immediately, ejects the tape and turns itself off. · Even if [STANDBY-ON] is pressed during OTR, the unit continues recording. Time(s) 1 time 2 times 3 times 17 times Display 0:30 1:00 8:00 Recording length (normal recording) 30 minutes 60 minutes 480 minutes COPYING A VIDEO CASSETTE (Requires a VCR or camcorder) TV/VCR You can make copies of video tapes made by friends or relatives for your enjoyment. WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. Connect your unit and a source (Playing) VCR using the following diagram. [This unit] B PLAY FWD D C A STOP/EJECT HEADPHONE VIDEO L ­ AUDIO ­ R [Fig. 8] Audio/Video cable (not supplied) [Ex: Source VCR or camcorder] AUDIO L OUT R VIDEO OUT IN IN 1 Select the channel to be recorded Use the Number buttons or [CH. NOTE: · If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box. 2 Select the tape speed Press [SPEED] to select the desired tape speed (SP/SLP). 3 Begin OTR OTR (2 : 30) Press [I REC/OTR] on the unit as many times as needed. The recording length will be determined by the number of times you press [I REC/OTR]. Each time it is pressed, the recording time will be increased by 30 minutes up to 8 hours. SP 1)Insert a pre-recorded video cassette into the source VCR or camcorder. 2)Insert a blank video cassette or one you want to record over, into the unit's cassette compartment. 3)Press [SPEED] on remote control for the unit to select the desired recording speed (SP/SLP). (Example: "7/04" for July 4th) Then press [B]. - - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:B 61 7/04 MON -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:- For every day recording : To record a TV program at the same time on the same channel every day. (Example: Monday through Sunday) ­ TIMER PROGRAMMING ­ BEGIN END -:- -:- -:- -:- -:- -:- -:- -:- - Press [L] until "EVRY DAY" appears, then press [B]. CH DATE - - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:B 61 EVRY DAY -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:- For weekly recording : To record a TV program at the same time on the same channel every week. (Example: every Monday) Press [L] until "EVRY" and your desired day of the week appear together, then press [B]. CH DATE - - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:B 61 EVRY MON -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:- - -/- - - - - -:-:- -:- -:- -:- -:- -:- -:- -:- - ­ TIMER PROGRAMMING ­ BEGIN END - *Recording period is SHADED - 31 - EN 5 Set beginning hour ­ TIMER PROGRAMMING ­ CH DATE - - -/- - - - - - -/- - - - - - -/- - - - B 61 7/04 MON - - -/- - - - - - -/- - - - - - -/- - - - - - -/- - - - BEGIN END -:- -:- -:- 7:12PM -:- -:- -:- -:- -:-:-:-:-:-:-:-:- Use [K / L] until the desired hour appears. (Example: " 7, PM" for 7:30PM) Then press [B]. 6 Set beginning minute ­ TIMER PROGRAMMING ­ CH DATE - - -/- - - - - - -/- - - - - - -/- - - - B 61 7/04 MON - - -/- - - - - - -/- - - - - - -/- - - - - - -/- - - - BEGIN END -:- -:- -:- 7:30PM -:- -:- -:- -:- -:-:-:-:-:-:-:-:- Use [K / L] until the desired minute appears. (Example: "30" for 7:30PM) Then press [B]. NOTES: · The display will not be turned on automatically at the time the programmed recording begins. To watch the currently recorded TV program or to play a DVD disc, press [STANDBY-ON] and [SELECT] to choose the TV/VCR mode or the DVD mode. If the tape runs out before the end time, the unit · will switch to the stop mode immediately and the tape will be ejected. TIMER PROGRAM EXTENSION To shift the time schedule of an automatic timer recording. 3)Press [RECORD] and select the desired program using [K / L]. Each additional push will shift forward the begin/end time for recording by 10 minutes. When the recording is already in progress, each additional push will shift forward the end time only. If you want to cancel while setting, press [PAUSE F] on the remote control. [. . . ] Aunque no aparezcan los segundos, empezará a contar desde 00 cuando presione [SETUP]. Utilice esta característica para sincronizar el reloj con la hora real. GRABACIÓN GRABACIÓN NORMAL TV/VCR SOLO puede ver el mismo programa que se está grabando. 5 Presione [STOP C] para detener la reproducción. MENÚ DE DISCO DVD-V 1 Presione [DISC MENU]. ¡Aparecerá el menú principal de DVD. ¡Si no existe la función, puede aparecer el símbolo en la pantalla de TV. ¡Si el menú de disco existe en el disco, aparecerán 1 Seleccione el canal a grabar Presione los botones numéricos o [CH. [. . . ]