User manual FURMAN PWRPORT

[. . . ] Petaluma, California 94954-6919 USA Phone: 707-763-1010 Fax: 707-763-1310 Web: www. furmansound. com E-mail: info@furmansound. com Remote AC Power Controller MODEL PowerPort Owner's Manual About the PowerPort Thank you for purchasing the Furman PowerPort Remote AC Power Controller. By installing this PowerPort you will minimize the risk of damage that can be caused by surges, faulty wiring and even lightning strikes. An individual PowerPort provides control, timing, monitoring, and power conditioning capability for a single 20-amp circuit. All critical circuit functions are governed by an internal microprocessor. [. . . ] Remember -- operating the front panel slide switch does NOT affect the stored state of the Possible Cause: An abnormal condition exists. Action Needed: Verify that line voltage and earth ground are okay. If both are okay, contact factory service. Possible Cause: PowerPort is receiving either 80-90 or 130-140 volts. Consider installing a Furman AR-PRO or AR-1215 voltage regulator. Symptom: POWER STATUS Indicator flashes (and therefore power to the outlets does not switch on). Possible Causes: (1): The input voltage is nearly out of or not within the acceptable range. 2): The front panel REMOTE (NORMAL)/ON/OFF (OVERRIDE) switch is not positioned to REMOTE (NORMAL), making the PowerPort unable to accept a remote command. Action Needed: (1) Check and correct incoming voltage. (2) Check the switch and make sure it is positioned to REMOTE (NORMAL). Symptom: EXTREME VOLTAGE Indicator flashing. Possible Cause: Input voltage is below 80 or above 140 volts, causing power to PowerPort's outlet to be shut down. 20A MAX STATSHUT+12V US REM GND DOWN 20A 120 VAC 60 HZ INPUT MADE IN USA 2400 WATTS REMOTE CONTROL CLASS 1 WIRING Front Panel Rear Panel Front Panel Features PROTECTION OK: This LED is normally on when the outlet is on. If an extremely large spike is encountered that exceeds the PowerPort's capacity, the main group of input protectors will blow an internal fuse, causing this indicator to go out. If LED is not lit when the outlet is on, full protection is not functioning. Spike protection may still exist, but will have a reduced capacity to absorb current. If this LED is not lit, please contact the Furman Service Department. GROUND OK: Normally on when the outlet is on. It lights if a reasonably good safety ground exists. If this LED is not lit when the outlet is on, the unit is not properly grounded. Unplug the PowerPort and correct the ground. Upon initially applying power to the PowerPort, this indicator will be lit if the inlet is receiving below 80 volts or more than 140 volts, and power will not be applied to the outlet. If the unit has been operating with an acceptable input voltage and then that voltage goes out of the acceptable range, PowerPort will shut off power to the outlet and this LED will begin flashing. [. . . ] DOUBLE UNIT RACK MOUNT: The PWRKIT-2 is for mounting two PowerPorts, side by side, into a single 19" wide rack space. PWRKIT-2 consists of: Two each: 401104-1275 brackets. Two each: 410002-820 small rack ear "A". Eight each: 860034-905 6-32 x 1/4" Phillips pan head screws, black oxide. [. . . ]