User manual FURMAN RS1

[. . . ] Shipping charges to the factory or repair station must be prepaid by the owner; return-shipping charges (via UPS Ground) will be paid by Furman. This warranty applies only to the original owner and is not transferable. Also, it does not apply to repairs done other than by the Furman factory or Authorized Repair Stations. [. . . ] Also, please enclose a note giving your name, address, phone number and a description of the problem. NOTE: All equipment being returned for repair must have a Return Authorization (R/A) Number. To get an R/A Number, please call the Furman Service Department, (707) 763-1010 ext. Please display your R/A Number prominently on the front of all packages. RS-1 RS-2 REMOTE SYSTEM CONTROL PANELS 0005-082003-D AC POWER SEQUENCING RS-1 AND RS-2 REMOTE SYSTEM CONTROL PANELS RS-1 AND RS-2 REMOTE SYSTEM CONTROL PANELS power product to the +V terminal of the RS-1 or RS2. Next, connect the REM terminal of your power product to the REM terminal of the RS-1 or RS-2, and your installation is complete. Most newer Furman products default to ON if the REM input is left open or tied to GND. This allows normal front panel operation if the unit is not being used with a remote control panel. It is recommended that where long wire runs (> 200 ft. ) or noisy environments are encountered, 2-pair cable be run, even if the indicator is not needed. This allows rejection of AC noise and interference by tying the REM input to GND when the unit is on. For installations using 2-pair cable, +V and REM connections are identical; just add wires from the STAT terminal to STAT terminal, and GND terminal to GND terminal. Though the connection doesn't require a shielded cable, in particularly noisy environments a shielded cable can be used by connecting the shield between the GND terminals of the product and the RS-1 or RS-2. RS-1 MAINTAINED CONTACT REMOTE CONTROL PANEL RS-2 The RS-1 Remote System Control Panel is an attractively finished key switch designed for use in single-gang wall mount boxes. It can control, from one location, all Furman power products that have remote capability, such as the Furman AR-PRO, ASD-120, MiniPort-15, MiniPort-20, PowerLink, the PowerPort, PS8R, and the PS-PRO. Multiple units can be controlled simultaneously. The RS-1 features a two-position key operated switch, an indicator LED, and can be easily installed in any electrical switch box with a minimum depth of 1-1/4". On the rear is a printed circuit board with a standard size terminal strip for wiring connections. The RS-1 may also be compatible with other AC power distribution and sequencing products. [. . . ] Finish: black epoxy powder coat. RS-1 AND RS-2 WIRING INSTRUCTIONS FPO Connecting the RS-1 or RS-2 Remote Control Panel is easy. For the simplest of installations, a single pair cable will suffice (standard 24-28 AWG telephone wire is fine). To enable the RS-1 or RS-2's SYSTEM ON indicator, it will be necessary to run a 2-pair cable. [. . . ]