User manual FURMAN SB1000

[. . . ] Front Panel Please save the packaging materials!The 1 "UPS1" Power Switch UPS`s shipping materials are designed to Turns power ON/OFF to the UPS1 outlets on provide protection during delivery. materials are invaluable if you ever have to return the UPS for service. Damage during 2 "UPS2" Power Switch transit is not covered under the warranty. [. . . ] 3) Connect the telephone If you wish to protect a fax or modem, connect the telephone cable from the wall outlet to the "IN" jack. Connect the telephone cable (provided) from the "OUT" jack to the fax or modem. These ports are not for network protection. 4) Connect to the utility power Plug the UPS to a grounded AC receptacle. 3 Avoid using extension cords. If used, make sure they are rated for at least 15 amps. 5) UPS self-test The UPS will conduct a self-test each time it is switched on. Do not add or remove any equipment while the UPS conducts this selftest; wait until the Power indicator lights up, once completed, switch on your equipment. 6) Overload protection If an overload situation (more than 5 amps load) is detected during self-test, the UPS audible alarm will activate, emitting a long beep and then will automatically shut down the system. If this occurs, unplug at least one piece of equipment from the battery supplied outlets. Switch off the UPS, wait 5 seconds and check to make sure the circuit breaker is set, then switch it on again. 7) Optimal battery status To maintain the optimal status of the battery, leave the UPS plugged in at all times. 8) Self-protection feature The UPS is equipped with a self-protection feature which prevents people from tampering with the unit and subsequently damaging it. It is programmed so that once it is switched off, the user must wait 5 seconds before switching it on again. 9) Storage Cover and store the UPS with the battery fully charged. During extended storage, recharge the batteries every three months to ensure battery life. SB-1000 MANUAL OPE R AT I O N 1) Operation check It is recommended that the user perform a simulation test when using the UPS for the first time or when adding an additional piece of equipment. Conduct a simulation-test: first, switch on the UPS and wait for the power indicator to light up, then simply unplug the UPS to simulate a utility failure. 2) Check the power requirement of your equipment A. Make sure the total power of your equipment does not exceed rating capacity. Also make sure the equipment you plugged into the Battery Power-Supplied outlets does not require total power exceeding the capacity of the UPS (600W / 1000VA). Otherwise, overload may occur and cause the circuit breaker to trip. 3) Limited rating power of UPS When a utility failure occurs, the UPS output outlets will supply power to your equipment from its battery, and the alarm will beep every 5 seconds. Be sure that your equipment is running under the limited rating power. [. . . ] Manufacturer shall not have any other obligation with respect to the Products or any part thereof, whether based on contract, tort, strict liability or otherwise. Under no circumstances, whether based on this Limited Warranty or otherwise, shall Manufacturer be liable for incidental, special, or consequential damages. Manufacturer's employees or representatives' ORAL OR OTHER WRITTEN STATEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by Purchaser, and are not a part of the contract for sale or this limited warranty. This Limited Warranty states the entire SB-1000 MANUAL obligation of Manufacturer with respect to the Product. [. . . ]