User manual FURUNO 1932

[. . . ] C Yo u r L o c a l A g e n t/D e a le r 9-52, A shihara-cho, N ishinom iya, Japan Te l e p h o n e : Te l e f a x : 0 7 9 8 -6 5 -2 111 0798-65-4200 A ll rig h ts re s e rv e d . Printed in Japan FIRST EDITIO N P : : JAN. OM E-34410 (H IM A ) M O D E L1832/1932/1942 SAFETY INSTRUCTIONS "DANGER", "WARNING" and "CAUTION" notices appear throughout this manual. It is the responsibility of the operator and the installer of the equipment to read, understand and follow these notices. If you have any questions regarding these safety instructions, please contact a FURUNO agent or dealer. WARNING Do not open the equipment. [. . . ] Select pulselength for 1. 5 and 3 mile ranges. Press the [ENTER] key to enable manual tuning. While pressing and holding down the [GAIN] control, operate the omnipad. "MANUAL" appears at the top right-hand corner when manual tuning is in effect. Select "On" to display the waypoint mark. select EBL reference for relative or true. Select distance unit of VRM and cursor for nm, km or sm. Turn watchman on (set rest period) or off. Select the display on stand-by; display "STBY" or navigation data, or go into the economy mode. Select condition which triggers guard alarm; in or out. Display the cursor position in strength whitch trigger guard alarm. Dispalay the cursor position in range/bearing or lat/long. Select minimau echo strength which triggers guard alarm. Select "On" to display the dead sector. Test keys, ROM and RAM, check antenna rotation speed, and display program no. Go to the installation setup menu. 11. Installation Setup 18 3. 11 Function Keys The function keys (F1 and F2) work like the auto-dialing feature of a telephone, automatically executing the function assigned to them. The function can be turned off by pressing appropriate function key again. Default settings 3. 12 Suppressing Noise Electrical noise can be suppressed by turning on "8. NOISE REJ" on the OTHERS menu. 3. 13 Adjusting Brilliance of Markers "2. Mark Brill" on the OTHER menu adjusts the brilliance of markers such as the cursor. F1: Shift (brief press) or Zoom (long press) F2: Ring brillience How to register menu items 3. 14 Outputting Target Position Target position data can be output to the navaid in IEC 1162 format. Press and hold down the [TLL] key to output the data. This function requires position data and heading signal. 1. [. . . ] The vector tip shows an estimated position of the target after the selected vector time elapses. It can be valuable to extend the vector length to evaluate the risk of collision with any target. Past position Display The Auto Plotter displays equally time-spaced dots (maximum 5 dots) marking the past positions of any targets being tracked. If a target changes its speed, the spacing will be uneven. [. . . ]