User manual FURUNO FA-100 OPERATORS MANUAL

[. . . ] UAIS TRANSPONDER FA-100 C Your Local Agent/Dealer 9-52, Ashihara -cho, Nishinomiya, Japan Telephone: Telefax: 0 7 9 8 - 6 5 - 2111 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION C1 : : S E P. O M E -4 4 1 7 0 (Y O S H) F A- 100 SAFETY INSTRUCTIONS WARNING ELECTRICAL SHOCK HAZARD Do not open the equipment. Only qualified personnel should work inside the equipment. Immediately turn off the power at the switchboard if water leaks into the equipment or something is dropped in the equipment. [. . . ] Where no shore based AIS or GMDSS sea area A1 station is in place, the AIS should be switched manually as in paragraph 1. 11. 2. A regional operating area is set with the procedure below. The most recent eight areas are memorized. · · · · · · · · Automatic setting of VHF DSC (channel 70) from shore-based AIS Automatic setting by AIS message from shore-based AIS Setting by shipboard system such as ECDIS Manual setting The default area is as follows: Tx power: 12. 5 W Channel no. 2087, 2088 Frequency bandwidth: 25 kHz Tx/Rx mode: Tx/Rx 1. 11. 1 Viewing channels, Tx power Do the following to view current channels. Press the [6] key to open the SYSTEM SETTINGS sub-menu. Press the [2] key to choose SET CHANNEL. [SET CHANNEL] 1 VIEW CHANNEL 2 CHANNEL EDIT SET CHANNEL menu 22 1 OPERATION 4. Press the [1] key to show the VIEW CHANNEL display. Power [VIEW CHANNEL] POWER : 12. 5W CHANNEL NO. CH-A: 2087 CH-B: 2088 Channel VIEW CHANNEL display 5. Press the [MENU] key to close the display. 1. 11. 2 Displaying, editing regional operating area status You may display the status of regional operating areas currently memorized in the equipment. Nine of any combination of AIS message from shore-based AIS, DSC message, manual settings and commands from ECDIS or a PC may be registered and one will be a default value. About registering areas · AIS and DSC messages registered within last two hours cannot be edited. · An item labeled DEFAULT cannot be registered. ("DEFAULT" are data used for international waters not controlled by shore-based AIS. ) · If two areas overlap one another the oldest data is deleted. · Data older than five weeks is deleted. · Area data is deleted when it is more than 500 miles from the area for which it was registered. 1. Press the [6] key to open the SYSTEM SETTINGS sub-menu. Press the [2] key to choose SET CHANNEL. Press the [2] key to open the CHANNEL EDIT sub-menu. [CHANNEL EDIT] SELECT NO. 1 TIME: - -/- - - - -: - FROM MMSI: DEFAULT TYPE: DEFAULT EDIT : [ENT] CHANNEL EDIT sub-menu, page 1 SELECT NO. : File number, 1-9. In order of distance from own ship, from closest to furthest. TIME: Data and time equipment controlled by external source. MMSI: MMSI displayed for control by DSC or shore-based AIS. [. . . ] Total number of sentences needed to transfer the message, 1 to 9 2. Sequential message identifier, 0 to 9 4. Encapsulated ITU-R M. 1371 radio message 6. Checksum AP-25 APPENDIX VHF channel list Ch No. [. . . ]