User manual FURUNO GD-1710C OPERATORS MANUAL

[. . . ] COLOR VIDEO PLOTTER GD-1700C COLOR VIDEO PLOTTER GD-1710C VIDEO PLOTTER GD-1700 Your Local Agent/Dealer 9-52 Ashihara-cho, Nishinomiya, Japan Telephone : fax : 0798-65-2111 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : APR. OME-44090 ( HIMA ) GD-1700/1700C/1710C *00080918401* *00080918401* *00080918401* *OME44090G00* *OME44090G00* *OME44090G00* SAFETY INSTRUCTIONS WARNING ELECTRICAL SHOCK HAZARD Do not open the equipment. Only qualified personnel should work inside the equipment. Do not disassemble or modify the equipment. [. . . ] To acquire another target, terminate tracking of an unnecessary target as shown in the paragraph 3. 25. 4. If not displayed, press the [HIDE/SHOW] key to display the radar soft keys. Place the cursor on the target to acquire, then press the ACQ soft key. Press the RETURN soft key. The plot symbol changes over time as below. A vector appears about one minute after acquisition, indicating the target's motion trend. Vector 01* At acquisition 01* 1 min. after acquisition Target Number * = Target number shown when TARGET ID NUMBER is turned on in the ARP SETUP menu. ARP plot symbols Automatic acquisition The ARP can acquire up to ten targets automatically by setting an automatic acquisition area. When automatic acquisition is selected after acquiring targets manually, only the remaining capacity for targets may be automatically acquired. For example, if seven targets have been manually acquired, three targets may be automatically acquired. Press the [MENU] key to show the main menu. Press the ARP SETUP soft key to show the ARP SETUP menu. Operate the cursor pad to select AUTO ACQUISITION AREA. Press the EDIT soft key to show the automatic acquisition area window. AUTO ACQ. AREA v ¡ ON ¤ OFF w Automatic acquisition area window 5. An acquisition area of 2. 0 to 2. 5 miles in range and ±45º on either side of the heading line in bearing appears. Note: Targets being tracked in automatic acquisition are continuously tracked when switching to manual acquisition. Automatic acquisition area 45° port 2. 0 - 2. 5 nm 45° starboard Automatic acquisition area 3. 25. 3 Displaying target number (ARP, TTM) Target number can be shown for ARP and TTM targets as below. . 125nm . 250/SP H-UP 319. 9°T TARGET TRAIL TLL OUTPUT 01 ARP Target Number ACQ TARGET INFO RETURN + ARP target number 1. 7. 359. 9°R 0. 240nm Press the [MENU] key. Select ON or OFF (default setting) as appropriate. Press the [MENU] key to close the menu. 3-37 3. RADAR OPERATION 3. 25. 4 Terminating tracking of ARP targets When ten targets have been acquired, no more acquisition occurs unless targets are cancelled. If you need to acquire additional targets, you must first cancel one or more individual targets, or all targets, using one of the procedures below. Terminating tracking of selected targets 1. Place the cursor on the target to terminate tracking. [. . . ] 2-29 entering by range and bearing . . . . . . . . . . . . . . . . . 2-31 entering with cursor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-29 erasing from the menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-34 erasing from waypoint list. . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]