User manual FURUNO GP-80 OPERATORS GUIDE

[. . . ] GPS NAVIGATOR GP-80 Operator's Guide The purpose of this operator's guide is to provide the basic operating procedures for this equipment. For detailed information, refer to the operator's manual. Selecting Display Mode Press [DISPLAY SEL]. Enlarging/Shrinking the Display Enlarging: Press [ZOOM IN]. [. . . ] 2) Operate the cursor keys to position the cursor where desired. To erase any mark (except MOB), place the cursor on the mark and press [CLEAR]. Selecting Mark Shape/Line Type 1) Press [MENU ESC] [2]. 2) Press v or w to select Mark Shape (or Mark Line). 3) Press t or s to select mark shape (or mark line) desired. 5) Press [MENU ESC]. Registering Routes 1) 2) 3) 4) 5) 6) 7) 8) Press [WPT RTE]. Repeat steps 6 and 7 to complete the route. Press [NU/CU ENT]. Entering Event Mark Press [EVENT MOB]. Setting/Cancelling Destination Destination can be set four ways. Below is the method for setting destination by the cursor. 3) Place the cursor on position to set as destination. To cancel destination, press [GOTO] [5] [NU/CU ENT]. Entering MOB Mark Press [EVENT MOB] until "Save MOB position" appears (about three seconds). Stopping/Starting Plotting and Recording of Track Press [PLOT ON/OFF]. [. . . ] 8) Enter comment (maximum 12 alphanumeric characters). 9) Press [NU/CU ENT]. The buzzer may be silenced by pressing [CLEAR]. 950950KO PUB. NO. OSE-43740-A ( 0 0 0 0 , TATA ) G P - 8 0 [. . . ]