User manual FUTABA MC230R

[. . . ] When mounting the receiver to such a chassis, use thick double-sided tape to mount the receiver as far away from the chassis as possible. Always install a motor noise killer capacitor. [. . . ] ·Power requirement: Nicd battery 6~7 cells (7. 2~8. 4V) ·PWM frequency: 1. 5kHz (fixed) ·Setting: One-touch input by pushbutton switch. ·Current capacity (FET rating): Forward=90A, reverse=45A ·Case size: 27. 1x333x12. 8mm (excluding protruding parts) ·Silicon cord gauge size: AWG16 equivalent ·Weight: 44g (including connectors and switches) ·BEC voltage: 6. 0V Symbol: ; Prohibited ; Mandatory Meaning Procedures which may lead to a dangerous condition and cause death or serious injury to the user if not carried out properly. Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or procedures where the probability of superficial injury or physical damage is high. Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, if not carried out properly. SET UP Neutral, high, and brake MAX points setting Set the steering angle adjustment function (ATV) to 100% and the ABS function and acceleration function to OFF using the transmitter throttle channel function. If the steering angle is too large or the ABS and acceleration functions are on, erroneous operation may occur. *When using the ABS function, after setting up the MC330CR, stop the reverse function, then turn on the ABS function. If the ABS function is on, the MC330CR cannot be set up correctly. PROTECTION CIRCUIT OPERATION The following protection circuits are built into the MC230CR. When a protection circuit operates, remove the cause before operating the model again. Overcurrent protection Heat protector Low voltage operation When an overcurrent flows due to an output short circuit, etc. , the overcurrent protection circuit automatically limits the current to protects the FET. Remove the cause of the short circuit, etc. When abnormal heating of the FET due to an overload, etc. is detected, the heat protector operates so that the speed is gradually reduced. When the FET temperature drops, the heat protector automatically resets. [. . . ] (Brake operation only) (Pushbutton switch operation) (Power switch) *Becomes brighter nearer the brake MAX point. 1 Reverse function cancellation While pressing the pushbutton switch, ON set the power switch to ON. * When desired, you can enable the cancelled reverse function by repeating the operation shown at the left. (The reverse function is switched alternately. ) (Amp power left on alarm) Blinks. [. . . ]