User manual FUTABA MC330R

[. . . ] When mounting the receiver to such a chassis, use thick double-sided tape to mount the receiver as far away from the chassis as possible. Always install a motor noise killer capacitor. Also, do not forget to service the brushes, and other parts. If noise causes the receiver to operate erroneously, control may be lost and an extremely dangerous situation may occur. INSTRUCTION MANUAL ·No part of this manual may be reproduced in any form without prior permission. [. . . ] (Black) is minus. When making adjustments, remove the motor, or place the model on a stand, so that it cannot run. (Red) Miniature screwdriver When going to and returning from the circuit, and when storing the model, always remove the Nicd battery. If the switch is turned on erroneously, control may be lost or a fire may start. MC330CR Power switch [MC330CR Technical Data] Accessory. Use to press the pushbutton switch. Receiver connector Connects to the receiver throttle channel. Special Markings Pay special attention to the safety at the parts of this manual that are indicated by the following marks. Mark (Specifications are subject to change without prior notice. ) ·Operating system: Forward, reverse, and brake operations are all linear. ·Power requirement: Nicd battery 6~7 cells (7. 2~8. 4V) ·PWM frequency: 1. 5kHz (fixed) ·Setting: One-touch input by pushbutton switch. ·Current capacity (FET rating): Forward=200A, reverse=100A ·Case size: 27. 1x333x12. 8mm (excluding protruding parts) ·Silicon cord gauge size: AWG14 equivalent ·Weight: 45g (including connectors and switches) ·BEC voltage: 6. 0V Symbol: ; Prohibited ; Mandatory Meaning Procedures which may lead to a dangerous condition and cause death or serious injury to the user if not carried out properly. Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or procedures where the probability of superficial injury or physical damage is high. Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, if not carried out properly. SET UP Neutral, high, and brake MAX points setting Set the steering angle adjustment function (ATV) to 100% and the ABS function and acceleration function to OFF using the transmitter throttle channel function. If the steering angle is too large or the ABS and acceleration functions are on, erroneous operation may occur. *When using the ABS function, after setting up the MC330CR, stop the reverse function, then turn on the ABS function. If the ABS function is on, the MC330CR cannot be set up correctly. PROTECTION CIRCUIT OPERATION The following protection circuits are built into the MC330CR. When a protection circuit operates, remove the cause before operating the model again. Overcurrent protection Heat protector Low voltage operation When an overcurrent flows due to an output short circuit, etc. , the overcurrent protection circuit automatically limits the current to protects the FET. Remove the cause of the short circuit, etc. When abnormal heating of the FET due to an overload, etc. is detected, the heat protector operates so that the speed is gradually reduced. When the FET temperature drops, the heat protector automatically resets. However, remove the cause of the overheating before operating the model again. When the Nicd battery voltage drops, this function limits the motor output current and ensures steering operation. [. . . ] (The previous settings are retained. ) * The confirmation beep sounds only when the motor was connected. Off On Off Cancelling the reverse function MC330CR ·Continuous rapid blink The amp reverse function can be cancelled by the following method so that the model can be used even in races that prohibit reverse running. (Brake operation only) (Pushbutton switch operation) (Power switch) *Becomes brighter nearer the brake MAX point. 1 Reverse function cancellation While pressing the pushbutton switch, ON set the power switch to ON. * When desired, you can enable the cancelled reverse function by repeating the operation shown at the left. (The reverse function is switched alternately. ) (Amp power left on alarm) Blinks. [. . . ]