User manual FUTABA T4

[. . . ] Voltage: 4. 8 volt DC Travel time: 0. 6 second end to end. Thrust: 41 lbs ·COMPLETE AIRBORNE SYSTEM: Consist of receiver, 4 servos and battery pack including switch and harness. Weight: 15 oz with 500 MAH Nickel Cadmium battery supplied. Voltage: 4. 8 volts DC. BATTERIES: Before initial hook-up and operational check, transmitter and receiver batteries should be charged for 24 hours. BATTERY PACK "ON" FOR CHARGING CHARGING INSTRUCTIONS: Your transmitter contains a built-in transformer type nickel cadmium battery charger. [. . . ] The trim lever located to the left of this stick control the neutral position of the servo which is activated by moving the stick vertically. The trim lever located directly below the right control stick is used to control the neutral position of the servo that is activated by moving the stick horizontally. The auxiliary or 5th channel is controlled by the lever located Just below and to the left of the output meter. Each of the four main controls is trimmable by the four trim le- vers. The auxiliary or 5 channel is not independently trimmable. Two sets of control stick knob of different lengths are supplied with this system, since individual preferences for control stick length may vary. Stick knob may be interchanged by merely pulling the knob directly away from the stick. The replacement knob should be pushed onto the stick until it is fixed. RECEIVER: This receiver has been factory tuned and adjusted to the transmitter, no further adjustments are requiredand the receiver should not be tampered w i t h . Attach to the receiver is the antenna, one 7pin plug and 2 jacks. The seven pin plug connects the receiver battery pack and supplies power to the receiver and servos. The multi connectors jack is for the rudder, throttle, elevator and auxiliary the aileron servo. Note: Receiver connector has a white dot on one end. For auxiliary (5th) channel, plug servo into this end of connector. OPERATION CHECK: 1. Connect servo plugs to receiver jack, next connect receiver to battery pack. 2. Collapse transmitter antenna and turn the switch on. All servos should stop at the neutral position. Make sure that each of the servos operates correctly and responds to the individual stick and trim lever. This test should be performed at least 20 yards from the receiver. Don't test for longer than 5 minutes. [. . . ] Return only the system, separate from your installation. Remove servos from mounts, remove foam padding from receiver. Plugs or other modifications w h i c h interfer w i t h factory testing procedures w i l l be returned to factory standards at your expense. Carefully pack a l l components i n d i v i d u a l l y with s u f f i c i e n t packing material to prevent s h i p p i n g damage. [. . . ]